4-Way to 5-Way Adapter Recommendation for a Reverse Lock Out Solenoid
Question:
2002 Ford Super Duty, Existing 3 pin + ground flat connector. Recently installed new surge disc brakes that require a backup signal. Guess I need 4 pin + ground in a flat connector. Is there a kit that allows me to remove existing 3+ receptacle and install new 4+ receptacle
asked by: Wayne R
0
Expert Reply:
What you need to convert the 4-way on your 2002 Ford Super Duty is the part # 20036. This will plug in to your 4-way and will then allow you to run a wire to tap into the reverse light circuit of your vehicle so that your reverse lockout solenoid will activate in reverse.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Tow Ready 4 Pole to 5 Pole Trailer Wiring Adapter
- Trailer Wiring
- Wiring Adapters
- Single-Function Adapter
- 0 - 5 Feet Long
- 4 Flat
- Plug and Lead
- 5 Flat
- Tow Ready
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Braking, Wiring, and Charge Kit for Flat Towing 2013 Ford Edge
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can a 4-Way Trailer Connector be Plugged Into a 5-Way Vehicle End Trailer Connector
- Q&A: Parts Needed to Install 5-Way on 2019 Toyota RAV4
- Article: Trailer Tire Sizing
- Article: My Trailer Hitch Doesn't Fit
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Q&A: Recommended Trailer Hitch for a 2024 Toyota RAV4
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Replacing 4-pin Plug with a 5-Way Plug So I Can Back My Trailer
- Q&A: 5-Way For 2023 Jeep Grand Cherokee L