Replacement Crank Handle Recommendation for a Stromberg Carson Jack part # JET-3500

Question

Question:

Can I buy a replacement override but for LCI 3500 power jack?

asked by: Brad H

0

Expert Reply:

For a replacement crank handle for your Stromberg Carson Jack part # JET-3555 you would want the part # JCH-1.

expert reply by: Jameson C

0

Answer 1

You should be able to manually crank the Electric A-Frame Tongue Jack, #JET-3555, up and down by removing the rubber plug on the side and inserting the manual handle or a properly sized socket wrench. Turn clockwise to extend the jack and…

view full answer...

Answer 2

It is likely that the interior gears have stripped due to the jack over-extending. Since manually cranking the jack is unsuccessful, you will probably need to replace the jack, as the jack manufacturers will smash or otherwise distort the end of the…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 5

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 6

Since the Ultra-Fab Electric A-Frame Jack #UF97FR has a triangular bolt pattern it would rotate the jack 120 degrees and may or may not work for your application. There are other jacks which have multiple mounting patterns on the flange like the…

view full answer...

Answer 7

I agree, that note doesn't make sense. When I reached out to my contact at MORryde they said the MORryde RV Generator Slide Out Tray #MR79RR doesn't have a stopper for when the tray is in the fully opened position so you just need to make…

view full answer...

Answer 8

On GM vehicles of that vintage, the 12-V pin should be hot regardless of whether the ignition is on or not. If it isn't showing voltage even with the ignition on, you're almost certainly on the right track thinking it's a blown or…

view full answer...

Answer 9

This is a pretty common issue with aluminum frames so we definitely have a options available for you. With that being said, the 8 inch frame height will make things a bit more difficult, but not impossible. First, the Curt TruTrack Weight…

view full answer...

Answer 10

Thank you for the picture. That kayak carrying device certainly does look cumbersome. Quite the interesting contraption. While generally we do not recommend modifying products like this, but I am happy to help if I can. With the bar being only…

view full answer...

Answer 11

You do have a very interesting situation. When it comes to aluminum trailers we always defer to the manufacturer whether it is just a utility trailer or an RV trailer like your toy hauler. Aluminum frames can't always withstand the pressure of a…

view full answer...

Answer 12

The switch circuit board is accessible for the MaxxAir MaxxFan Mini Roof Vent w/ 12V Fan #MA00-04401M once you're able to pull down the control panel, but since connecting the power wires is part of the installation you might consider just tying…

view full answer...

Replacement Crank Handle Recommendation for a Stromberg Carson Jack part # JET-3500

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching