Replacement Frame Brackets for Reese Weight Distribution Systems

Question

Question:

does both right and left side w/handle?

asked by: Howard

0

Expert Reply:

The part # RP21501 includes one lift bracket. If you need two brackets you would want the part # RP6637 instead. This comes with a lift handle as well.

expert reply by: Jameson C

0

Answer 1

Replacement Lift Brackets with Handle for Reese Weight Distribution Systems #RP6637 that you were looking at is a kit that includes 2 of the Replacement Lift Bracket for Reese Weight Distribution Systems #RP21501. This is the current bracket offered…

view full answer...

Answer 2

Hey Travis, congrats on the new 2024 Jayco Flight 284BHS! Your travel trailer looks to have a GVWR of 7,950 lbs so I recommend going with the Equal-i-zer Weight Distribution w/ 4-Point Sway Control #EQ37121ET and pairing it with the Shank…

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 5

You're welcome Chris! Sounds like you've more then got the hitch covered. I can not think of a better option then the TorkLift SuperHitch Magnum Trailer Hitch item #TL74FR. You will be able to pull anything and everything with this hitch and…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

Yes, the lift brackets part #RP6637 and the chain part #3216 would work with the Pro Series RB3 weight distribution part #PS49582 that you have.

view full answer...

Answer 8

For RV's that have laminated siding with decent density, there frequently is no backing installed. Awnings such as the Solera Smart Arm 12V Power RV Awning, #LC517517 are screwed into the siding using self-taping screws. Other times the awnings…

view full answer...

Answer 9

The Replacement Lift Brackets, #RP6637, will fit on trailer frames that are 3 inches tall or greater and up to 2-1/2 inches wide along the top. I added a photo of the brackets on a 2 inch by 3 inch trailer frame for you to see. The lift brackets…

view full answer...

Answer 10

While snap up brackets like the Replacement Hook Up Brackets for Curt Weight Distribution Systems #C17208 are somewhat interchangeable, I would still recommend using like branded brackets. The Pro Series weight distribution hitches are manufactured…

view full answer...

Answer 11

If you use the Curt hitch extender part #C45048 in the 24 inch length with a weight distribution system the towing capacity is 8,000 lbs. If the 24 inch length would work for you this would be a great option.

view full answer...

Answer 12

It sounds like you are looking for a set of lift brackets for a weight distribution system. Although it would be helpful if I knew which system you currently have, lift brackets are fairy universal therefore you would more than likely be able to use…

view full answer...