2 Inch Trailer Coupler Locks that Can be Keyed Alike for a Fleet of Trailers

Question

Question:

I have a fleet of trailers. Can this be ordered with keyed alile keysinch ?

asked by: Dwayne K

0

Expert Reply:

We have several coupler locks for 2 inch couplers that can be ordered keyed alike but the Gorilla Guard # 63228 is not one of them. I have included a link for you to the ones that can be ordered keyed alike.

A lock such as # e98895 is similar to the Gorilla Guard. You would just select the keyed alike option, near the add to cart button on the product page, select the quantity and they will all be keyed the same.

expert reply by: Michael H

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 3

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 4

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Answer 5

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…

view full answer...

Answer 6

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 7

I recommend checking out the Optronics LED Combination Trailer Tail Lights #TLL160RK as they are pretty standard and can replace quite a few versions of a wraparound tail light set. These measure 8-1/16" x 2-7/8" and carry the…

view full answer...

Answer 8

The correct replacement key for your etrailer Hitch Receiver Lock #e98881 with key code 029 would be Replacement Key for etrailer Hitch and Coupler Locks #e75UR.

view full answer...

Answer 9

The pilot diameter of a wheel is only crucial for if the wheel is hub-centric (meaning it centers to the hub using the pilot hole of the wheel), and not lug centric (means the lugs are what centers the wheel). The #AM20504 has a pilot diameter of…

view full answer...

Answer 10

Feel free to email me your pictures and measurements, I would be happy to take a look at those for you. In the mean time, since you mention that the bearings blew out, you will want to examine the spindle to make sure that it wasn't damaged. As…

view full answer...

Answer 11

Yes, for your 2020 Jeep Grand Cherokee that isn't equipped with the factory tow package, the Tekonsha T-One Vehicle Wiring Harness #118727 will work perfectly. This custom harness is going to plug into existing ports behind the tail lights and…

view full answer...