Replacement Taillight and Wiring for Thule Transporter Hitch Mounted Cargo Carrier # TH665C

Question

Question:

Where can I find replacement wiring for Thule 665C, Im assuming Ill need the complete kit. The passenger side connection to the taillight is broken and not repairable.

asked by: Michael

0

Expert Reply:

I spoke with my contact at Thule and to replace the passenger side taillight wiring harness on your Thule Transporter Combi Hitch Mounted Enclosed Cargo Carrier, # TH665C, you will need part # TH05254.

If the connection point on the taillight was damaged, we offer the Replacement Tail Light, # TH05252, as well.

expert reply by: Leah S

0

Answer 1

It's true! We (and other customers - see review below) have found that the Micro-Flex LED Tail Light #STL35RB works great as a replacement for the stock assemblies on the Thule Transporter Combi Cargo Carrier. LEDs typically last significantly…

view full answer...

Answer 2

I have a solution for you, but unfortunately the bolt patterns for most bike racks like your Thule rack tend to be proprietary, and aren't generally able to be matched. Instead, I recommend replacing the hitch pin. You can do this one of two…

view full answer...

Answer 3

Yes, the LED light part #STL35RB can be used to upgrade the lights in a Thule Transporter Hitch Mounted Cargo Carrier part #TH665C. I went out to the warehouse and test fitted the LED lights inside the original grommet that comes with the Transporter…

view full answer...

Answer 4

If you are talking about the Taillight #TH05252 on your Thule Terrapin, then yes, there is only one bulb in the taillight. Since the whole unit is sealed you actually have to replace the whole light assembly with the part #TH05252 that I referenced.…

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

Yes, the Curt Custom Fifth Wheel Installation Kit for Ford #C93WR will work just fine with the Demco Autoslide 5th Wheel Trailer Hitch w/ Slider #DM8550040.

view full answer...

Answer 11

The correct Roadactive kit that fits your 2023 Ford F-150 is the part #RAS3611-YHD. I really like the RAS kits as they basically don't have any downsides. You get the adjustable support, an easy install, no maintenance, and actually improves…

view full answer...

Answer 12

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Replacement Taillight and Wiring for Thule Transporter Hitch Mounted Cargo Carrier # TH665C

Products Referenced in This Question

Continue Researching