Using Bearing Buddies on 10K Axle With Oil Bath Hubs
Question:
We are looking for grease buddies for a Dexter 10,000 axle Looking to change from the oil bath bearing to a high temp. Grease bearing Thank you
asked by: Grease B
Expert Reply:
Although they're most frequently used on boat trailers, you can use a Bearing Buddy on just about any trailer. You'll want to make sure to install a double lip grease seal, and be careful not to overfill hub. Even with a double lip seal, many folks tend to overfill their hubs and end up blowing out the seal (myself included.)
I did some research, and found that the hub bore of the typical 10K axle is around 3.5 to 4.3 inches in diameter, which is larger than any of the Bearing Buddies available. However, if you'd reply with the inside diameter of your hub bore or the reference number from your outer bearing and if your oil caps thread in or are driven in I'd be happy to check for you.
You can simply drain the oil from your hubs, give the bearings and interior of the hub a good cleaning to remove any traces of the oil, and pack the bearings with grease. I'll link you to an article showing you how to pack the wheel bearings.
Product Page this Question was Asked From
Bearing Buddy Bearing Protectors - Model 1980A w/ Auto Check - Chrome Plated (Pair)
- Trailer Bearings Races Seals Caps
- Caps
- Bearing Protector Grease Cap
- 1.98 Inch
- Bearing Buddy
more information >
Continue Researching
- Shop: Equalizer for 2-1/2" Wide Slipper Springs - LH or RH - 18-3/8" Long - 1" Center Hole
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2
- Q&A: Wiring Diagram for Trailer Breakaway Kit
- Search Results: slipper spring equalizer
- Search Results: 473336
- Search Results: equal~i~zer
- Shop: Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles
- Shop: Equalizer for 2-1/2" Wide Slipper Springs - LH or RH - 24-7/8" Long - 1" Center Hole
- Shop: Dexter Tandem-Axle Trailer Equalizer Kit for 2-1/2" Slipper Springs - 18-3/8" Equalizers
- Shop: Replacement Trailer Hub Bearing - 28580
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Q&A: Replacement 5 Leaf Slipper Spring for a Tandem Axle Dump Trailer with Two 6K Axles
- Search Results: 44649
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Video: Choosing the Right Trailer Wiring
- Q&A: Replacement for Demco Master Cylinder 05680-C for Drum Brakes
- Search Results: 25580
- Shop: Trailer Wiring
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: 05680-C Master Cylinder Replacement for Trailer Recommendation
- Shop: Brake Controller
- Search Results: dust cap
- Search Results: 68149
- Shop: Gooseneck Hitch
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: Brake Controller Installation: Starting from Scratch
- Shop: Fifth Wheel Hitch