Where to Mount the Trailer Valet Jack and Trailer Mover # STC-V211 on Trailer with Folding Coupler

Question

Question:

I finaly got my trailer valet for Christmas this year and was woundering were can I mount this if my boat trailer has a swing away hitch Thanks

asked by: Hugh B

1

Helpful Expert Reply:

You would want to mount the Trailer Valet Swivel Jack and Trailer Mover # STC-V211 behind the hinge of your swing away coupler. This way you will still be able to fold the coupler away when you park your trailer.

expert reply by: Jameson C

1

Answer 1

If the incline is slight and the gravel isn't super deep the Trailer Valet XL part #TVXL25 would work. But if you have a steep driveway and/or deep gravel the wheels of the Valet are going to spin. In the video I attached a link to we show the…

view full answer...

Answer 2

We actually carry a few different document holders for your to choose from for your trailer. Here is a list you can choose from. Peterson Certificate Holder #PM46 Buyers Products Document Holder for Trailers #3375201100 Peterson Certificate Holder…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 5

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 6

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 7

The 8-14.5 tires are an older metric size no longer used today. Therefore, you would need to replace these along with the wheels in order to update them. In order to see if we have any options for you, we'd first need to determine the bolt…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

I would be happy to! The bottom of the foot to the center of the pipe mount is 10-1/2" when retracted and 24-1/2" when fully extended on the Trailer Valet JXS Trailer Jack w/ Footplate and Drill Powered Option item #TV64FR. Sorry I do not…

view full answer...

Answer 10

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 11

I definitely understand how safety chain capacities and determining exactly what chain rating you need for your trailer can be a bit confusing. To keep it as simple as possible, safety chain requirements state that the breaking strength of EACH…

view full answer...