Offset of Wheel Included with Karrier # AM32181 Wheel and Tire Combo

Question

Question:

I'm interested in this wheel and tire, AM32181. Whats the offset?

asked by: Maurice T

0

Expert Reply:

The Karrier ST215/75R-14 tire is mounted on a white powder coated 14 x 5-1/2 rim. The rim has a zero offset, a 5 on 4-1/2 inch bolt pattern and a 3.19 pilot opening. The tire has an 1870 lb capacity at 50 psi.

expert reply by: Mike L

0

Answer 1

Since your tires are 215/75-14 its likely you have a 5 on 4-1/2 bolt pattern. You should measure to be sure. I've linked an article to help you determine what you have. I've linked our selection of tire and wheel combinations that…

view full answer...

Answer 2

The wheels for your ST215/75R14 sized tire on your 2022 Coleman Lantern 17B are 14" X 5-1/2" wheels with a 5 on 4-1/2 bolt pattern. The Karrier ST215/75R14 Radial Trailer Tire with 14" Galvanized Wheel - 5 on 4-1/2 - Load…

view full answer...

Answer 3

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 4

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…

view full answer...

Answer 5

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 6

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this…

view full answer...

Answer 7

Your math is correct in your trailer weight load example. If a fully-loaded tandem axle trailer weighs 4000-lbs then each of the 4 tires will bear 1/4th of that load, or 1000-lbs. In this case a tire rated for 1300-lbs would provide a good safety…

view full answer...

Answer 8

You can add larger wheels and tires to a trailer as long as you have enough room for the larger size. The main clearance issues we find when putting larger tires and wheels on a trailer is from the top of the tire to the fender and from the inside…

view full answer...

Answer 9

Even though I cannot comment specifically on the grease you used because I am not familiar with it, I can tell you the best grease for trailer bearings is a a grease with a rating of GC-LB, which just means it is made to withstand very high…

view full answer...

Answer 10

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

view full answer...

Answer 11

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Answer 12

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Offset of Wheel Included with Karrier # AM32181 Wheel and Tire Combo

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching