Tang Dimensions of the Demco 2-Tang Clevis # DM12676-30

Question

Question:

What is the diameter of the holes on the tangs and what is the measurement between the two tangs.

asked by: Travis

0

Expert Reply:

I spoke to my contact at Demco and he informed me that the distance between the tangs of the # DM12676-30 is 2-1/4 inches and the hole diameters that are on the tangs are 1-1/8 inches in diameter.

expert reply by: Jameson C

0

click to enlarge

Answer 1

You're not going to have any problems mixing Dexter and Lippert components on trailer axles over 10k-lbs in the same manner as below 10k-lbs as long as the measurements on the replacement parts are the same- i.e. bearing sizes are the same, etc..…

view full answer...

Answer 2

You will want to use a circuit tester like part #PTW2993 and check the #4 terminal on the back of the 7-way trailer connector on your trailer for power. This is the 12-volt power terminal so there should be power to that terminal. You will need to…

view full answer...

Answer 3

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 4

I had the Demco 2-Tang Clevis - Adjustable Channel Mount #DM05593-97 measured and from end to end, it will be 9 1/4 inches long.

view full answer...

Answer 5

The mounting holes are 2 inches on center for the clevis and 3 inches on center for the mount. The clevis and side of the bracket has holes that are 0.64 inch. The top and bottom holes of the mounting bracket are 0.48 inches and the center hole is…

view full answer...

Answer 6

I spoke with my contact over at Demco about clevis #DM05593-97. The squares at the back are 1.88 inches square. And the space between the upper and lower tangs is 2 inches. I have included a picture showing these measurements for you.

view full answer...

Answer 7

That is a pretty good guess! The two position mounting channel in the #T1812200 is 3-1/2" wide x 7-1/2" tall as shown in the included diagram. I included a video review of the #T1812200 for you to take a look at.

view full answer...

Answer 8

The diameter of the mounting holes of the #T0897900 are 5/8 inch. We also have this as a kit with the channel and mounting bolts/nuts with part #T1812200.

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Tang Dimensions of the Demco 2-Tang Clevis # DM12676-30

Product Page this Question was Asked From

Continue Researching