2016 Nissan Rogue Mud Flaps

My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…

I have added a photo detailing the wiring connections for the Pollack Heavy-Duty, 7-Pole, Round Pin conncetor, #PK11700, see link. This is a SAE J560 compliant connector. The wiring diagram for the vehicle side connector, #PK11720, is pictured…

We do offer the Trailer Connector Adapter, #HM47425, which converts a 7-pole round connector to a 7-pole flat connector. This adapter works for tow vehicles with combined taillight wiring, meaning that the turn signals and brake lights run on the…

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based…

I spoke to my contact at Horizon Global. He said it is acceptable to mount the Bulldog Powered-Drive Kit #BD1824200100 to the slave jack itself. He also said that if you need to switch the motor wires to make it work correctly, that would be fine,…

The 22 mm size that is mentioned for the Wheelmaster lug nut part #WM9062 that you referenced is the size of the thread.

We have a really great kit that comes with everything…

According to your owners manual, you can absolutely flat tow your specific model. It is not recommended to tow this vehicle over 65 mph. You will also need to start the engine and allow it to run for five minutes at the beginning of each day and…

Bill yes, the Brass Tire Sensors for TST TPMS #TST-507-RV-S2 will work great with your TST TPMS for RVs - Color Display - Signal Booster #TST-507-RV-4-C. These sensors were designed specifically to be used with that system as well as the 6 sensor…

The thread size is…

The replacement reverse lock out you are looking for is the part #TK71-755-00. This would allow you to use the same adapters and fittings you have now.

We actually have the Brake Buddy 32220 reverse solenoid available with the Titan Solenoid Valve Replacement Kit #TK71-755-00. The solenoid itself would be an exact replacement and it features the two mounting holes at the bottom like you described…