Videos
for Work Lights
Help Articles
for Work Lights
Expert Answers
for Work Lights
The Opti-Brite LED Work Light #TLL60FB is a 2-wire light with black being power and white being ground. It will wire in to your trailer's existing wiring. As long as the current lights run on 12, 24, or 36 volt DC this light is compatible.
view full answer...The Replacement LED for Tow-Rax Recessed Lights #TWPWLS110V50W that you referenced most likely would work fine on your trailer that has flood light buckets already installed in it. This is designed to fit internal bucket dimensions of…
view full answer...Hey John, yes the Tekonsha brake controller install harness part #3050-P is correct for your 2023 Nissan Frontier and would be what you would need to install the Prodigy P2 part #90885. This harness has one end that was designed to fit your truck…
view full answer...Hey John, To determine the correct replacement leaf springs for your trailer you'll want to jack up one side to take the pressure off the leaf springs and then can measure from the center of one eyelet to the center of the other eyelet.…
view full answer...The connection on the Seaflo Submersible Utility Pump #SE54FR is designed to fit a hose with an inner diameter of 13 mm.
view full answer...Yes, the 0.9 Cu Ft Greystone Standard RV Microwave - 900 Watts #324-000105 is a great replacement for your Advent model MW912B as the only real differences is the Greystone being 1/8" taller without the trim, and being about 1" less deep.…
view full answer...On a 7-Way connector the suggested minimum wire gauge for the White (ground) wire, the Red or Black (power) wire, and the Blue (brake power) wire is 12 gauge. The minimum wire gauge for the remaining Green (right turn/brake) wire, the Yellow (left…
view full answer...An individual LED type light may not put out as much light as certain individual halogen lights do, but because, as you noted, LEDs use so little power you can use more of them. You could potentially BOTH increase your overall light output and still…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...To replace the shock in your Titan model 10 actuator you are going to basically need to disassemble the actuator so that you have access to the shocks. Instead of describing to you how it comes apart I thought it would be more helpful if you had an…
view full answer...We have not yet replaced the Shock part #T1242600 on a Titan Model 10 Surge Brake Actuator so I do not have any specifics for you but I have attached a parts diagram which shows you how the unit is broken down. You can then use this to get a better…
view full answer...The Transcom #TCM 21344 TB cross references to the 10-10 seal we offer, part #RG06-090. The seal has a 2.125 inch ID and a 3.376 OD. It's compatible with a 25580 inner bearing.
view full answer...