Hey Ewdard, The RV Awning UV Protectant and Conditioner #BE85FR should really only need to be applied once a season. That being said, it really depends on your climate. If you're in a rough desert-like climate with a lot of Sun…

Before applying the #GG64FR Spray-On Ceramic 3-in-1 Wax, Griot's Garage strongly recommends removing the existing wax using a product such as the Foaming Surface Prep, part #349B3101. If the existing wax isn't…

Not 10 foot, the longest gray water drain hose available is indeed the 4 foot #W01-4048.

The best way to ensure the graphics on your new trailer stay crisp and sharp is to make sure you always have a good coat of wax on the trailer. This coat of wax is going to act as a protectant which will shield the graphics/decals whether they be…

No, the MaxxAir II RV and Trailer Roof Vent Cover w/ EZClip #MA26JR that you referenced does not come with a bug screen.

The correct big screen for the MaxxAir II RV and Trailer Roof Vent Cover part #MA26JR is the Replacement Bug Screen for MaxxAir II RV and Trailer Roof Vent Covers part #MA10-20121.

You will need to turn on the headlights of your tow vehicle (with the trailer connected of course) to power the LED Marker Light RV Side Cameras #FCE48TASL. The yellow trigger wire is for the turn signal function whether you are installing this on…

Retainers are not included with the Replacement Bug Screen for MaxxAir II RV and Trailer Roof Vent Covers #MA10-20121. This part comes with just the screen, which will snap into the vent cover.

We do have the Dexter Trailer Springs Over-Under Conversion Kit #K71-385-00 that will allow you to use an underslung axle on your trailer. The Dexter Trailer Axle w/ Electric Brakes #8327816-EB is a 5,200lb axle. It includes 12"…

We offer the Griot's Garage Spray On Ceramic 3 in 1 wax in a gallon size with part #GG64FR.

The Bright Way Trailer Brakeaway Kit #3802308 has a built in 1-AMP charger. So when your truck is connected it will be charging. There should be no draw going out while the trailer is disconnected so it should be ready to rip whenever…

I was able to narrow down your 2019 Heartland Mallard M32 to having the Lippert stabilizer jacks. They will be either the 5-1/2" to 5-5/8" Pads #SN68FR or the 5-3/4" to 6" Pads…