Videos
for RV TV Mount
Help Articles
for RV TV Mount
Expert Answers
for RV TV Mount
Hey David; I checked directly with Pace Edwards for you and can tell you that the rails on the Pace Edwards Switchblade Retractable Hard Tonneau Cover #PE46QJ will protrude just under 3/4" on both sides when installed on your Ford Super…
view full answer...Thanks for reaching out, Michael! The Dexter Electric Trailer Brakes #K23-086-087-00 are compatible with 3,500 lb axles and have the standard 4-bolt pattern so if that matches the specs of your axle then this will definitely work for your…
view full answer...Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks will have…
view full answer...I checked the install manual for the MORryde Wall RV TV Mount part #MR82ZR and there were no stipulations for mounting orientation but the location of the handle will change if you choose to mount it so it slides out to the left. That said, you…
view full answer...I was able to get ahold of MORRyde for their technical drawings of the MORryde Ceiling RV TV Mount - Flip Down - Full Motion #MR24RR, and through that I was able to get some useful dimensions for you. This mount has an overall height of…
view full answer...The MORryde Wall RV TV Mount #MR23ZR has dimensions of 5.25" W x 5.83" T for the plate that attaches to the wall. The MORryde Wall RV TV Mount #MR65ZR has dimensions of 10" W x 5.87" T for the plate that attaches…
view full answer...Hey Jason, I spoke with Furrion and they stated that the Furrion Chill Cube is OEM only currently and should be released to the aftermarket distributors later on this year (2024), but there is no solid date. That says to me that they're…
view full answer...With a ladder on the back of your RV it is unlikely you will still be able to fold up the 24 x 84 etrailer Cargo Carrier for RV Bumpers #e96ZR. Reason why is when the carrier folds up it takes up all the space of the bumper, so unless your bumper…
view full answer...The MORryde Snap In Wall RV TV Mount #MR25ZR will hold the TV 3-7/16 inches from the surface it is mounted to.
view full answer...If the trailer is less than 1 inch off of being perfectly level either up or down then it will be perfectly fine. Having it slightly higher would be better because presumably the tongue weight of the trailer will pull it down a little. You could also…
view full answer...Thank you for all of the info you gave. Based on that you'd want the trailer hub and drum part #AKHD-545-35-K that you referenced and then for brake assemblies to match you'd want the #AKEBRK-35-SA which is a self adjusting set for both sides…
view full answer...If you wish to remove the stickers on your Draw-Tite Trailer Hitch Receiver #76128 you can certainly do so. To help with taking them off, you might try using a heat gun or blow dryer to apply heat on the stickers first, which will make it easier for…
view full answer...