Filter Products
Filter Results
$193.74 - $368.78
$124.81 - $139.73
Filter by Amp Conversion - Female to Male
$193.74 - $368.78
$124.81 - $139.73
Videos
for RV Power Cord
Help Articles
for RV Power Cord
Expert Answers
for RV Power Cord
Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…
view full answer...The best way to determine the weight capacity of your leaf springs would be to check the weight rating of the axle on your trailer. The trailer will have a plate or sticker on it that will list the VIN number. The weight rating of the axle should…
view full answer...Blue Ox has base plate kits that fit your 2023 GMC Yukon XL with the part #BLU54VR which fits the AT4 models with 4L and the part #BLU58FR which fits the non-AT4 models. While we haven't had the chance to shoot an install video for either…
view full answer...The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…
view full answer...Yes we have a 14 inch version of the Aluminum Viking Series Valhalla trailer wheel with the part #AX02455545BMFL. This is 5-1/2 inches wide and has the standard 5 on 4-1/2 inch bolt pattern that 14 inch trailer wheels have. I attached a picture of…
view full answer...The AL-KO trailer hub part number 8700 that you have is a 3,500 lb trailer hub/drum with a 5 on 4-1/2 inch bolt pattern. Based on that the #AKHD-545-35-EZ-K is the correct fit and would work great.
view full answer...Your 2008 Chevy HHR should have a set of rails on the roof that run from front to back. Which means we have the Rhino Rack part numbers #RRVA106B-2 and #RRSX100 as a confirmed fit, but the kit you mentioned is not a fit.
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...We have just what you are looking for. I called my contact at TDE and asked about the hub you have on your boat trailer. They told me that it was a 5-stud idler hub for a 3,500-lb axle. That means you need the part #AKIHUB-545-35-K. This is a fit…
view full answer...The Adco SFS AquaShed Truck Camper Cover part #290-12264 is what I recommend for your Lance Truck Bed Camper Model 1010. The Adco SFS AquaShed is durable, has zippered panels for access inside, and has weighted buckles to help with installation.…
view full answer...