Videos
for RV Cargo Slides
Help Articles
for RV Cargo Slides
Expert Answers
for RV Cargo Slides
Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the…
view full answer...What you need for your Isuzu NPR truck is a powered converter #C59236. It is compatible with incandescent and LED trailer lights. I have included a link to the installation instructions for you. This harness does require a direct connection to the…
view full answer...The Tekonsha OEM Vehicle Wiring Harness #22121 that you referenced includes all the wiring and parts necessary to install a fully functional 7-Way connector and trailer brake controller. The included brake controller harness is compatible with and…
view full answer...The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.
view full answer...In order to install a brake controller on a dump truck you'd first need to start with a 4-way trailer connector and then adapt this to a 7-way so you can hook up a brake controller. I won't have…
view full answer...My contact at Yates Rubber advises that a nominal 8-inch keel roller does not measure exactly 8 inches; typically they are slightly smaller than the specified size, much the way a piece of 2 x 4 lumber is not exactly 2-inches by 4-inches. I took…
view full answer...Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look…
view full answer...From what I could find, the #171255UC grease seal has an inner diameter of 1.719 inches and an outer diameter of 2.565 inches. These dimensions match our TruRyde Double Lip Grease Seals, #RG06-050. If possible, I recommend verifying the inner…
view full answer...I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be…
view full answer...I spoke with MORrdye, and they said that they do not have a dimensional drawing of the screw holes as their attachment uses TEK screws. They go on to mention that they've never had an issue reported as long as all the…
view full answer...The Dexter E-Z Flex Suspension Kit part #K71-653-00 will work just fine on 3,500 axles assuming the measurements match up which in your case they do. I have spoken to Dexter about this before and the weight capacity listed is more or less a guide…
view full answer...Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.
view full answer...