Videos
for Propane Fittings
Help Articles
for Propane Fittings
Expert Answers
for Propane Fittings
Hey David, from previous customers of ours who have the same 2020 Keystone Raptor 424 we have determined that your pin box style is the Lippert 1621 which means for a Gen-Y gooseneck adapter…
view full answer...To see all of the correct wheel and tire combos you'd need check out the link I attached.…
view full answer...A direct replacement for your Winntec Model 6020 is the Automatic Changeover RV LP Gas Regulator #37207-30395 as the BTU rating is compatible and they have the same fitting sizes.
view full answer...Yes, the #100019-24 pigtail can be used to connect your dual-cylinder 100 lb propane setup to the regulator on your RV. Since this hose does not have a back-check to contain a gas leak, you will need the #204120-MBS fitting that includes a…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...To add a 100 lb tank to your two 30 lb tanks, I recommend the MB Sturgis Sturgi-Stay T-Fitting w Hose - Type 1 Valve - Quick Disconnect, Disposable Cylinder Ports #103615. This will allow you to connect the red fitting to one of your tanks and the…
view full answer...You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is…
view full answer...You'll be able to connect your Weber Traveler Grill directly to that quick-disconnect fitting…
view full answer...The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...Based on the information you gave, although I can't help with the axle (other than to state it is…
view full answer...On oil bath hubs the seals are different than standard grease seals. The correct replacement for what you have is #91030. Unitized oil seals like this have a part that stays fixed and a part that rotates with the hub for optimum leak protection. I…
view full answer...I looked up the hose and the regulator you currently have, and found that the GHA7 hose uses an ACME Nut connector to the LP tank and a 1/4 inch male inverted flare that connects to the 3/8 to 1/4 adapter used on the regulator. We offer the…
view full answer...