Videos
for Camping Games
Help Articles
for Camping Games
Expert Answers
for Camping Games
Hey William, the E6 error on a Furrion wall thermostat indicates an Open circuit Humidity Sensor issue. Most likely the sensor is bad and needs to be replaced as this is a pretty rare error code.
view full answer...The Front Runner Slimline II Platform Rack #FR89MJ is the best way to carry a Tent #FR26RV on your 2024 Kia Sportage. The platform will attach to your raised roof rails and will allow you to attach the tent using their Kit #FR99RV.
view full answer...We currently have not had a Ford F-150 with the power outlet in the bed to test fit a bed mounted 7-Way #C57008. I see no reason you will not be able to still install the 7-way as there is a large gap which can be seen in the installation video…
view full answer...I reviewed all of our trailer wheel bolt inventory and did not have a match for your request. I also contacted our suppliers and was not able to make a match there. The bolts I found were not 13 threads per inch coarse, nor left-handed. I suspect…
view full answer...If the front part of your square-bodied coupler is approximately 3 inches tall, based on the inner dimensions of the lock the Blaylock EZ Lock Trailer Coupler Lock #BLTL-33 will work well for you. The #BLTL-33 has inner dimensions of 3-1/8 inches x…
view full answer...The Replacement Gear Motor with Pinion Gear #BVB0601-00 is the correct replacement for the Ventline Ventadome roof vent model V2119. It sounds like you also need the Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents…
view full answer...The rubber pads for the Rhino-Rack XTray Clamp Set unfortunately are not sold separately so you would either need to reach out to Rhino-Rack to see if they could ship you them or purchase a replacement clamp set #RRSP112.
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…
view full answer...We do have a trailer hitch receiver that fits your 2024 Nissan Pathfinder, from Curt. The correct part number is the following: - Curt Trailer Hitch Receiver #C46DR
view full answer...For your 2003 Nissan Xterra and Forest River Tent Trailer, I recommend the Equal-i-zer Weight Distribution System part #EQ37060ET which is rated for up to 600 lbs. The 400 lb system part #EQ37040ET would not be a good choice as this will be at the…
view full answer...I took a look online, the Curt Trailer Hitch item #C13105 you have on your Sienna is rated to be used with a weight distribution system. The best one for your 2,100 lbs pop up camper is going to be the Equal-i-zer Weight Distribution System item…
view full answer...I spoke with my contact at B&W who said that you will actually use those brackets to install the B&W Turnoverball Underbed Gooseneck Trailer Hitch #BWGNRK1116 on your 2017 Ford F-250 Super Duty FX. The only time that you will run into…
view full answer...