Videos
for Battery Charger
Help Articles
for Battery Charger
Expert Answers
for Battery Charger
You can put a maintenance charge on your trailer battery with the 12 volt accessory circuit of the 7-way. The 1:00 position of your 7-way carries this circuit. You would just need to run a length of 10 gauge wire like part #10-1-1 (sold by the…
view full answer...For a 12,000 lb. electric car trailer winch like the Bulldog Winch Trailer Winch part #BDW10040, I recommend a standard 12 volt lead acid battery rated up to at least 650 cold cranking amps (CCA). As long as the battery is rated up to 650 CCA then…
view full answer...Hey Steve, so the most similar option that would be an upgrade to what you have now would be the Redarc BCDC charter part #331-SBI12-BLD which will do a great job managing all of the batteries in your setup that need to be charged. This has an…
view full answer...I've contacted Brightway, who forwarded me a copy of the instructions they include with the…
view full answer...Another wire or harness is not needed on the 2023 Honda CR-V for the install of the Curt 4-Way Wiring Harness #C56370, but you do have to add 20 amp fuse to location #17 in the fuse box.
view full answer...Since the part #PD4655V has come out and has ability to switch between lithium and lead acid batteries the part PD4655LIV was discontinued. At one point there were separate parts for lithium and lead acid batteries but since the current one can do…
view full answer...The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only…
view full answer...I did some looking and found that the 46210 and 46845 hubs you currently have use the same #L68149 inner bearing and #L44649 outer bearing. However, as we do not carry the Tie Down Engineering Vortex hubs, I cannot say what all will fit them,…
view full answer...To charge the battery in the Engager Trailer BreakAway Kit, #20099, you can attach the wire from the 12 volt circuit on the trailer side 7-Way (1 oclock position on the back of the trailer side 7-Way where the wires attach) to the input wire on the…
view full answer...We do have the panels separately. What you're looking for is the Go Power Overlander Expansion…
view full answer...Hey Sean! As long as you don't have anything placing a draw on the Bright Way Solar Battery…
view full answer...Yes we have the Redarc In-Vehicle BCDC Battery Charger #RED96FR which essentially is the same thing as the charging system you referenced as it gives you a way to enhance the charging circuit ran to your 7-way to put the best charge on the trailer…
view full answer...