Videos
for Automotive Tools
Help Articles
for Automotive Tools
Expert Answers
for Automotive Tools
Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch being the following: - B&W…
view full answer...The vast majority of trailers on the market use a standard coupler (installed on top of the trailer frame) which is compatible with the B&W Continuum Weight Distribution System w/ Sway Control #BW28FR. Underslung couplers aren't as…
view full answer...Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…
view full answer...The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...Hey mark I can definitely try to point you in the direction of the correct hubs and brakes for your trailer. I was not able to find any useful references for the numbers you provided, but there are other ways to determine the correct hub. Do you…
view full answer...It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item #ET7WK. This includes a 7-Way connector, a…
view full answer...For the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" #C12172, there really isn't a solution other than to use a torque wrench. Without torqing the necessary bolts to the manufacturer specs, you void the warranty and can have…
view full answer...The only real difference between the Alpha Systems #AL74UV and the LaSalle Bristol #3441700534142711440 is that the Alpha Systems is made of TPO which is a bit less flexible than Elvaloy-based PVC that #3441700534142711440 uses; PVC is going to be a…
view full answer...Yes, you can. Given the B&W Continuum Weight Distribution System item #BW28FR unique design you do not have to back straight up to the trailer to hook it up to your truck.
view full answer...The Draw-Tite #76271 and our etrailer #e83ZR trailer hitch receivers do have a fairly similar construction. While the Draw-Tite is listed at a higher towing and tongue weight capacity these numbers do not mean a lot since both are rated for more…
view full answer...