Hi there Ryan; thanks for the question and the easiest weight distribution hitch to connect and disconnect after initial set up is the B&W Continuum, with the right one for your 2-1/2" hitch…

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The vast majority of trailers on the market use a standard coupler (installed on top of the trailer frame) which is compatible with the B&W Continuum Weight Distribution System w/ Sway Control #BW28FR. Underslung…

The information I have says the #306-X7162 has a ground clearance measurement of 10-1/2". The Curt #C13410 has approximately 12" to 12-1/2" of clearance when…

Hey mark I can definitely try to point you in the direction of the correct hubs and brakes for your trailer. I was not able to find any useful references for the numbers you provided, but there are other ways to determine the correct hub. Do you…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

For the Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4" #C12172, there really isn't a solution other than to use a torque wrench. Without torqing the necessary bolts to the…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

It is not recommend to jack up a trailer by the axle. This may cause damage to the axle itself. It also puts too much stress on the leaf springs. Instead, you will want to place the jack under part of the trailer frame preferably next to the leaf…

Hey Isaac! While we don't have one specific all in one kit we do have every component you will need to update your trailer's lighting and brakes. I recommend using the Trailer Wiring Kit item…

Since your Aventon Abound E-bike is heavier at 80 lbs you'd need our highest weight rated e-bike rack the Hollywood Racks RV Rider part #HLY64FR which has an 80 lb per bike capacity and also fits the 2 inch hitch of your…