The Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp part # PD4060K that you asked about is completely compatible with both using 6-Volt batteries in parallel and for use with AGM batteries. The built in smart charger provides several modes to help you not only charge but help to maintain the batteries and extend the life of them. view full answer...
Thanks for the question! When adding a slide topper there are time we can put these on a camper that has an awning already on the slide and times that we can't. In your case there isn't the 4" of room we would need to put it on. The topper requires that brackets be put on the top right and left of the slide below the trim flange that sticks out slightly from the slide. It appears that on your Keystone Cougar 34 TSB that the awning is at the very top edge of that topper (so it can clear... view full answer...
Thank you for purchasing the Furrion Vision S camera system from etrailer and though you didn't mention which camera system you purchased from us, I am more than happy to help our customers. Though I obviously cannot tell you what wires you have because there is no universal wiring colors, I can tell you that all you need to do is use the Cordless Circuit Tester # PTW2979 to find out which lights are your running lights or reverse lights (depending on what you want to use the camera for).... view full answer...
You are not required to use any lubrication when installing the Valterra Coupling for Rigid RV Sewer Pipe # F02-2103 that you referenced. You'd just need to slip it over the ends of the pipe and then tighten the band clamps and you'd be set! view full answer...
The Thule Hullavator Pro # TH898 requires at least 28.5" of usable bar space, and between 4"-8" of those need to be outside of the mounting feet of the roof rack. For this reason I recommend going with the 58" long bars on the # MPG216, which has aero style crossbars that will accept the Hullavator Pro and provide you with plenty of bar space to carry your kayak.
I've linked some installation and informational videos on these two products for you to have a look at as well. view full answer...
We have a great solution for you but unfortunately the Torflex Lift Kit - Single Axle - 2-5/8" Lift part # K71-723-01 is for use with only Torflex axles which I don't think you have. Instead you will want to use the Dexter Trailer Springs Over-Under Conversion Kit part # K71-384-00 for axles that are 2 3/8" diameter axles and the Dexter Trailer Springs Over-Under Conversion Kit part # K71-385-00 for axles that have a 3" diameter.
These kits are designed to take the axles from their... view full answer...
Yes, the Rack'em Backpack Blower Adapter # RA-STIHL that you referenced is needed to connect your Echo PB8010T blower pack to your Rack' em trailer rack. view full answer...
Yes, the Bulldog Winch Custom-Fit Steel ATV Winch Mount # BDW15151 that you referenced is compatible with Superwinch winches like your Terra45 since it uses an industry standard winch mounting pattern. view full answer...
I spoke with my contact at Lippert who said that there is a notch in the side of the cup holder that you should be able to feel with your hand. I attached a picture of where it is as well. Once you find it you will need to use a flathead screwdriver or a butter knife to pop it up. This will reveal 2 screws that you will need to take out before detaching the cup holder wiring from the arm.
She also said that when the massage function goes out this is typically something that is related... view full answer...
The numbers you provided really aren't an identifier for the lens or the lamp they came from so unfortunately it won't help much in identifying a replacement lens, as they're just numbers that signify that the lens meets DOT standards. However, the photo was pretty helpful (thanks for sending it in!)
To help conclusively match the lamp to the proper replacement lens, I'd need to know the following:
-Dimensions of Lens
-Center to Center Spacing of Screw Holes
-Any Identifying Numbers From... view full answer...
According to the owner's manual, Honda recommends installing chains on the front tires only. The manual states that because of the limited clearance to the inside of the tire, cable-type chains should be used. The cables needed will depend on the tire size. For a 235/60-18, use # PW1046 or for 235/65-17 tires, use # PW1046. Either set includes the rubber adjusters to keep the cables snug to the tires.
The Konig # TH01594247 chain you'd looked at would fit either tire size and is also... view full answer...
I have a solution for you but they don't make a specific kit for a 1-3/4" diameter axle like they do with the 2-3/8" item # K71-384-00.
To make your own conversion kit for a 1-3/4" diameter axle all you will need is the U-bolt kit Item # APUBR-10 and two of the spring seats item # TRSS175 you were looking at. view full answer...
For your 2022 Chevy Equinox that has a naked roof the roof rack I would recommend is the Inno Aero Bar Roof Rack part # INXB130-2, # INXS250, # IN43FR. This is a higher quality roof rack that beats it's competitors in price by quite a bit. It's still one of the nicer rack options that's going to fit well, install easy, and be quieter but it just comes in a much better price so I really like it. view full answer...
The Yakima BigCatch Kayak Roof Rack part # Y04091 is designed for heavier sit on top fishing kayaks. These types of kayaks have a much flatter hull than your standard recreational sit-in kayak. The carrier will still work with this style and you don't have to worry about it falling off but there are better options for this style like the Yakima DeckHand Kayak Roof Rack part # Y04083-2. The BigCatch will work for both but if you are that concerned with security, just get the BigCatch for... view full answer...
I have a similar brake controller solution that does work with the emergency braking system of your 2019 Ford Ranger with the P2 part # 90885 and the diode kit part # 7865 but Redarc doesn't have a diode kit yet to allow the Tow Pro Elite part # RED44FR to work.
This controller will work a lot better than any OEM controller for sure. view full answer...
Yes, the Saris Door County Bike Rack for 2 Electric Bikes # SAR42RR that you referenced can be used with a 20 inch and a 26 inch wheel without requiring adapters so it would work great for you. view full answer...
The Bottom Jack Cover # LC23UD of the Lippert jack # LC285318 has four screws in it that hold the top to it. You'll need to remove those screws first and take the top # LC285160 off. Once the top is off you can then dismantle the bottom cover from the jack and slide it off. view full answer...
Since your 2014 Grand Design Momentum 385TH has 8k axles the correct SumoSprings kit would be the part # SS26MV for if your axles are under your leaf springs or part # SS33HR if they are above instead. view full answer...
We have the FloTool RhinoRamps part # FT11912MI which are rated for 16,000 lbs. It provides a lift of up to 6-1/2 inches and works on up to 10 inch wide tires. view full answer...
We have the Firestone Coil Rite air bag kit part # F4150 that is a confirmed fit for your 2015 Nissan Armada SV and will allow you to add air pressure when needed to get rid of squat. This is a great and relatively easy solution to get rid of squat so we do recommend it. view full answer...