bing tracking image

Filter Questions and Answers:

reset filter

Expert Answers about Forest River


  • Which Kenda ST205/75/14 Tire Has A Speed Rating Above 65 MPH?
  • The Kenda Loadstar ST205/75D14 Bias Trailer Tire - Load Range C # AM1ST86 you were looking at has a speed rating of 65MPH. To tow your trailer at speeds above 65MPH I recommend going with the Karrier ST205/75R14 Radial Trailer Tire - Load Range C # AM10234 instead. This tire has an 81MPH speed rating, and it being a radial tire will give it improved traction and stability on paved roads due to the difference in ply design. At this time we do not have a bias ply tire in this size with a...
    view full answer...

  • How does the OEM Prep Pkg work on 2021 Chevrolet Silverado 3500
  • That's a lot of questions, let's get them answered for you. First, yes it does significantly change the install time, not only that but with the easy removal of the hitch when not in use you have full uninhibited use of your truck bed as if there was never a hitch to begin with. If your 2021 Chevrolet Silverado 3500 has the OEM Prep Package then you do not need to install additional under-bed rails or have need for the traditional style above bed rails such as the Curt, # C16429-204. The...
    view full answer...

  • What is Overall Length of Camco AccuLevel Trailer Bubble Level # CAM25563
  • The overall length of the Camco AccuLevel Trailer Bubble Level # CAM25563 is 10 inches in length overall and 3 inches tall.
    view full answer...

  • Amps of Service To Run Two Air Conditioners
  • Your question asked if 30-amp service would run two 14,500 BTU air conditioners, but you referenced Furrion # FR67FJ air conditioners which are 15,500 BTU's each.The 15.5K units draw 15.4 amps each when running - so that will not work. The Furrion # FR37FJ air conditioners are 13,500 BTU The 13.5K units draw 15.4 amps each when running. That will not work either. You could consider the Atwood # AT15027-22 air conditioner that is13,500 BTU This 13.5K unit only draws 11.3 amps each when...
    view full answer...

  • What is Needed to Install an Aftermarket Brake Controller on an 02 Dodge Ram With Factory 4 Flat?
  • Having the 4 Flat already installed makes getting up to the 7 Way easier. Our Universal Installation Kit for Trailer Brake Controller # ETBC7 will piggyback off your current 4 Flat to power the trailer lights and blinkers. The included wiring and circuit breakers will get everything else for the # 5504 powered and working properly. The 7 Way plug that comes with the # ETBC7 also has a 4 Flat plug on the side so you will not need to use an adapter to connect a trailer with a 4 Flat plug....
    view full answer...

  • Will Drilling Hole In Trailer To Mount CargoBuckle G3 IMF8800 Weaken Trailer?
  • The CargoBuckle G3 Retractable Ratchet Tie-Down Straps - Bolt On - 2" x 6' - 1,167 lbs - Qty 2 # IMF18800 you were looking at uses a 3/8" bolt to secure the strap to your trailer. This will not weaken the frame of the trailer given you drill the 3/8" hole directly in the center of the material on the trailer. You will want to make sure you are not drilling the hole right on the edge. I included a video of the # IMF18800 for you to take a look at.
    view full answer...

  • High-Quality Replacement Grill For Outside of RV
  • Thank you for the photo of your set up, and while we do have an option for a high-quality grill that will allow you to cook outside your RV, there isn't a grill that will fit in the exact mounting arm you have. So the best option we can offer is a grill with a new mounting rail, or the use of a grill stand: - Camco RV Olympian 6500 Stainless Steel Grill # CAM57245 - Camco RV Grill Mounting Rail # CAM57268 or - Camco Deluxe Folding Grill Stand # CAM57293 The Olympian 6500 comes with...
    view full answer...

  • Does The Kuat Transfer V2 Bike Rack Come With Locking Hitch Pin?
  • The Kuat Transfer V2 Bike Rack for 2 Bikes - 2" Hitches - Wheel Mount # KU84FR comes with a tamper-resistant bolt that tightens the carrier to a 2" receiver and you need to use the included security wrench to remove or install. So it technically does come with some sort of a locking device, but for more security to deter theft you can add Hitch Lock for Kuat Bike Racks - 2" Hitches # HL2. This will do a better job of actually locking the bike rack to the hitch receiver. Make sure you have...
    view full answer...

  • Recommended Shock Kit for a 2021 Puma 28' Travel Trailer
  • The Lippert 4,400 pound axles can have some odd measurements, so you will need to double check the diameter before going with one of the following kits. Both of these will use the same shock and the only difference will be the size of the U-Bolts and their mounting plates The Lippert # LC281281 is designed to be used with a 3 inch diameter axle, and the Lippert # LC281255 is designed to be used with a 2 3/8 diameter axle. Though there is drilling required for the install, all the parts...
    view full answer...

  • Recommended 5th Wheel Trailer To Gooseneck Hitch Adapter For Fabex 730 Pin Box
  • I do have a few options for you, but there is not a Goose Box or Gen-Y gooseneck pin box that will be an exact replacement for your Fabex 730 pin box. The first option is using the Gen-Y # GY38FR. You will need to drill a few holes in the brackets to match your trailer, but as long as you don't drill a bunch of extra holes or drill into any existing holes you will not void the warranty of the pin box. This is quite a bit of work so I recommend having a professional do this for you if you...
    view full answer...

  • Options For Reducing Sag While Hauling A Camper On A 2010 Toyota 4Runner
  • I really don't think that a weight distribution system is necessary for your situation. Your Toyota 4Runner components are tough enough to haul your camper, your suspension is the component lacking. That being said you can go two different routes. If you don't want to affect your ride quality when you're not hauling, I recommend getting the SumoSprings # SS68DR. These will engauge when the rear suspension sags enough to hit these springs. So it will not affect the first 40% of your suspension...
    view full answer...

  • What Is The Weight Capacity Of The Rightline Gear Kayak Carrier Foam Block RLK100K10?
  • The Rightline Gear Kayak Carrier with Tie-Downs - Foam Block Style - 14-3/4" Long # RL100K10 does not actually have a weight capacity. The roof rack weight limit or vehicle's roof weight limit is typically the limiting factor so you will want to check the capacity of each. It looks like you have the Rhino-Rack RR66YR which has a weight capacity of 165lbs. I was not able to verify the roof weight capacity on your 2011 Toyota Corolla, however, it is likely over 85lbs. You can check your...
    view full answer...

  • How To Wire 3-Wire Fuel Transfer Pump To Vehicle 7-way Connector
  • Since your transfer pump has 3 wires that means it has a static ground. The green wire will get grounded to the body/frame, the white wire will need to be connected to the ground on the 7-way connector, and the black wire will get connected to the 12v power pin on the 7-way connector. You can do this by using the 7-way connector # A7WCB, 10 gauge wire (sold by the foot) # 10-2-1, and heat shrink butt connectors # DW05745-5. You will connect the black wire to the 1 o'clock pin on the back...
    view full answer...

  • Will Ultra-Fab Dirt Bike Carrier Fit EcoHitch Invisi Trailer Hitch 306-X7257 On 2018 Subaru WRX?
  • You are correct that from the center of the hitch pin hole to the most outward part of the rear bumper with the EcoHitch # 306-X7257 installed is right at 3-1/2". Since from the center of the hitch pin hole to the closest part of the Ultra-Fab Dirt Bike Carrier for 2" Hitches # UF48-979033 is 15-1/2" you will have plenty of clearance to use this carrier with your 2018 Subaru WRX. The # UF48-979033 weighs in at 50lbs, so since your # 306-X7257 has a 525lb tongue weigh rating you will be...
    view full answer...

  • Replacement Hubs for a 1998 Tracker TrailStar Boat Trailer
  • With a 5 1/2 bolt pattern and the outer bearing being an # L44649, you most likely have Dexter's #84 Spindle. This uses the # L44649 (1.063 inner diameter) outer bearing and the # L68149 (1.378 inner diameter) as the inner bearing. This is one of the most common spindles out there, but it wouldn't hurt to verify your inner bearing's inner diameter just to make sure. If all that matches, the etrailer.com Trailer Idler Hub Assembly for E-Z Lube Axles # AKIHUB-545-35-G-EZ-K will be a great...
    view full answer...

  • Does Weight Of Weight Distribution Hitch Get Added To Tongue Weight Of Trailer?
  • The weight of the weight distribution hitch will actually not count towards the tongue weight of your trailer. So when you use the # BXW0356 you were looking at its 100lbs will not take away from the 350lb tongue weight rating of the trailer hitch receiver on your 2021 Kia Sedona. You will just need to make sure your trailers tongue weight does not exceed the 350lb tongue weight rating of your trailer hitch receiver.
    view full answer...

  • What 2021 Honda CRV Hybrid Hitch will Work with My 2-Inch Bike Rack?
  • Yes, the hitch that I recommend for your 2021 Honda CR-V Hybrid is the Curt Trailer Hitch Receiver Trailer Hitch Receiver # C13397. The Curt Hitch Receiver comes with all hardware needed and involves a bolt-on installation with no drilling. Also, if you do not have a hitch pin that came with your bike rack, you will need to purchase a hitch pin and clip # PC3. With this setup, you will be able to transport your 2-inch bike rack on your 2021 Honda CR-V.
    view full answer...

  • Can the Ultra-Fab 4K Electric A-Frame Jack Be Powered From the Vehicle
  • Yes, the Ultra-Fab Electric A-Frame Jack part # UF38-944016 can be powered from the tow vehicle's battery. I suggest simply attaching a trailer connector to the end of the power wire and extending if needed, similar to the etrailer Electric Jack with Footplate and 7-Way Plug part # EJ-3527-BBX. That said, the Ultra-Fab pulls more power than the etrailer so you really can't use the 7-way socket due to the wire gauge difference. I recommend installing part # PK11852 on the jack and part...
    view full answer...

  • Recommended Tire Chains for a 2007 Toyota FJ Cruiser
  • If you have the standard size 265/70-17 tires on a 2007 Toyota FJ Cruiser then we have some great options, my personal favorite is the Titan Chain Alloy Snow Tire Chain Set part # TC2326. These are cost effective, super easy to install, and perform really well.
    view full answer...

  • Recommended Low Profile Roof Rack for a 2018 Ford F150 SuperCab
  • The best low profile roof rack we offer for a 2018 Ford F150 SuperCab is the Rhino-Rack ROC25 Roof Rack part # RR29XR. This roof rack as you can see the feet sit inside the mounting feet as opposed to being on top. That said, they don't get much more lower profile than this as you are after all using accessories which wrap around these crossbars so you have to have enough clearance between the bottom of the bar and top of the roof.
    view full answer...