If you click the provided link, you can see the available 2 bike trunk mount racks that are a confirmed fit for your 2012 Scion iQ.
My favorite is the Thule OutWay, part # TH45JV. I'll admit, the rack isn't inexpensive, but the rack is unbelievably easy to install and remove. Usually, trunk mount bike racks use 6 straps and you'll need to adjust all kinds of buckles each time you want to install the rack onto the vehicle. The OutWay uses 2 rubber coated straps that allow the rack to be... view full answer...
The frame cradles of the Thule Passage 2 Bike Carrier # TH910XT are only rated for 35 lbs so you would not be able to carry a bike that weighs 57 lbs. I have a solution for you though.
You will want to go with a hitch mounted bike rack with enough capacity for the weight of your bike like the Saris SuperClamp Freedom EX2 part # SA4025F which has a 60 lb per bike capacity. Check out the review video I attached as well.
For a hitch you would want the Curt Hitch part # C11291. You will also... view full answer...
For your 2007 Honda Fit base model we have the Draw Tite hitch part # 24776 as a confirmed fit but the Curt # C11058 is not a fit for the non-Sport models. For trailer wiring too you'd need the part # 118420.
Then for a ball mount # 3593 and hitch balls # 19256 for a 1-7/8 inch ball or part # 19258 for a 2 inch ball. view full answer...
I spoke with my contact at Lippert and he informed me that the Center Point part # LC1565391 will support a 21,000 lb trailer. That being said, since you have a triple axle trailer you would want the part # LC1565401 instead. Bag failure is extremely unlikely but if it were to fail you would still be able to travel.
I attached a couple pictures that detail the installation. It basically just replaces you current equalizers and shackles. They attach to your hangers and then directly to... view full answer...
Your trailer has 7k Lippert axles on it so the disc brake kit you would need is the three sets of # K2HR712D for the disc/rotor and caliper kits. This won't be super cheap but it will give you the best option for converting to disc.
For an electric over hydraulic actuator kit you then would want the part # HS381-9067 which will give you everything needed except for brake lines. For that you then would want the part # HS496-253. view full answer...
For your 2012 Scion iQ the Curt hitch part # C11291 that you referenced is a confirmed fit and will work well. There's no drilling required to install this hitch but you may have to enlarge some of the access holes. The tongue weight capacity of this is 100 lbs which should be enough for the weight of a spare wheel and tire.
Curt requires the use of their stabilizer strap part # 18050 when using their hitch to carry a non-supported load like a bike rack or spare tire carrier. I attached... view full answer...
Go To Results