As long as the crossbars on your 2005 Infiniti QX56 are situated or can be adjusted so that they're between 20 inches and 57 inches apart, the Thule Canyon XT # TH859XT-8591XT roof cargo basket would be an outstanding choice. The basket is a very popular choice. If you click the provided link, you can see a product demonstration video featuring the Thule roof cargo basket. view full answer...
You got good advice. The Tekonsha Prodigy P2 # 90885 is an outstanding trailer brake controller that is easy to set-up and operate and that our customers have rated as a highly reliable product. In your 2011 Infiniti QX56 with the 7-way tow package you will use the quick-connect wiring adapter # 3050-P to install the P2. No other parts are needed. view full answer...
I did not see where you mentioned what electric over hydraulic actuator you are using but if it is the HydraStar Marine Electric Over Hydraulic Actuator part # HBA16 that you referenced then the first thing I recommend you check is that you are using the correct EOH setting on your brake controller. If this is confirmed I would then bleed the brakes which can be done using the attached photo.
If you still have issues with delays after you have done the above then please just let me know... view full answer...
To find out if the 20x60 Folding Cargo Carrier, # e98874, will fit on your 2010 Infiniti QX56, there are some measurements you will have to make. Measure from the center of the hitch pin hole to the furthest point at the end of the vehicle. If that distance is less than 9-1/2 inches, this carrier will fit when it is in the folded up position. view full answer...
According to Yakima, the MegaWarrior Extra Large Cargo Basket, # Y07080, will fit on the factory crossbars on your 2004 Infiniti QX56. Be sure you check your vehicles roof weight capacity to ensure it can handle the weight of the cargo basket, 35 lbs, plus the weight of the load you are carrying. This cargo basket has a weight capacity of 130 lbs.
For the best stability while driving, it is recommended to have at least a 30 inch crossbar spread. The crossbar spread is the distance from... view full answer...
I checked with Thule and the Thule Force XT XXL cargo box, # TH6359B, will fit on the factory cross bars on your 2012 Infiniti QX56.
Once you have your OEM crossbars positioned at least 23-5/8 inches apart you will place the box on the roof with the clamps around the cross bars, then move the box forward and rearward to allow for front and rear clearance, rear hatch mostly. Then, you will center the grips on the cross bars and tighten them down. Finally, load the box and secure the load... view full answer...
Thule has determined that the Force XT XXL Cargo Box, # TH6359B, will fit on the factory crossbars on your 2010 Infiniti QX56. I did some research on your vehicle and found that the roof weight capacity is 200 lbs, however, this cargo box has a weight capacity of 110 lbs. You should not exceed the weight capacity of the cargo box.
If the crossbars on your vehicle are adjustable, then I would recommend mounting this cargo box with the widest spread possible. This will provide more stability... view full answer...
According to my research the maximum capacity of your 2012 Infinity QX56 roof is 200 pounds. There are not aftermarket crossbar feet - they are custom to the crossbar rail and roof rails.
You can replace your crossbars with the Malone # MPG202 crossrails that have the highest weight rating at 165 pounds. These crossbars will attach directly to your front to back roof rails. I have attached a video review of this product. view full answer...
I have a great weight distribution system for your 2021 Grand Design Imagine 3100 RD Travel Trailer. It will help minimize trailer sway and ensure a level, stable ride when you are towing with your 2010 Infiniti Q56. It is the Blue Ox TrackPro Weight Distribution w/ Sway Control item # BLU87FR. This system has a tongue weight range of 800 lbs - 1,000 lbs and a gross towing weight of 10,000 lbs. It has a slightly higher capacity than your Infiniti and trailer but it will still provide a... view full answer...
The Thule T2 Pro part # TH83JV that you referenced has a 60 lb per bike capacity when used as a two bike rack but when using the add-on part # TH9036XT the overall bike rack is then limited to 160 lbs. This would mean for three bikes you'd be limited to 53 lbs per bike. view full answer...
Both the Tekonsha Prodigy P3 # 90195 with the Adapter # 3050-P and the Curt Spectrum # C51170 with the Adapter # C51382 are excellent brake controllers and I wouldn't hesitate to recommend either one for you to use with your 2008 Infiniti QX56. Even though they are both electric brake controllers the P3 is more of a traditional controller while the Spectrum is a new style of brake controller. Ultimately I recommend going with the Spectrum over the P3 because you can install it just about... view full answer...
If you have the factory 7-way connector on your 2012 Infiniti QX56, the connector used for the brake controller will be located under the driver side of the dash. I have attached a photo that shows what the plug-in adapter on the harness that connects between the brake controller and the vehicle connector looks like. If the pins on the connector you found under the dash match the pin pattern of the connector in the photo then that is your connector. You may have to remove a small panel... view full answer...
Due to the location of the backup camera and sensors, the GearDeck 17 Enclosed Cargo Carrier # H00604, and all other enclosed cargo carriers will interfere when backing up. Like your QX56, most vehicles with backup cameras and sensors are located in the bumper and around the lift gate handle. Because enclosed carriers install in the trailer hitch, they block most of that area.
The only way to use an enclosed cargo carrier and have full use of your backup camera and sensors is to use a... view full answer...
I recommend Quick Drain RV Sewer Hose part # D04-0121 that measures 20 feet long. You need the Valterra 3" Thetford Bayonet to 3" Standard Bayonet adapter part # T05-2285VP to fit into the Thetford elbow. view full answer...
I would recommend you install it below and to the right of the steering wheel, on the lower dash piece that will be nearest to your right knee. Check out the picture I attached to see this area.
I attached installation instructions as well as an installation video for this product for you to check out also. view full answer...
When no trailer is connected the light on brake controller # 39523 will either be flashing or off. If it is green all the time with no trailer connected that indicates a short to ground. This normally occurs when there is corrosion on the pins or where the wires attach on the trailer connector.
The Reese Pod brake controller should be connected as follows.
White - Ground
Black - 12 Volt Constant Power
Red - Cold Side of the Brake Pedal Switch
Blue - Trailer Brake feed to Trailer Brakes view full answer...
I will be happy to help. Starting with a brake controller we have many options but one controller stands out as my personal favorite, the P2, # 90885. This is our best selling controller of all time because it is easy to set up and use and it is reliable.
Installing it depends on how your 2010 Infiniti QX56 is set up. If your QX56 came with a factory installed 7-Way trailer connector at the back you can use wiring harness # 3050-P with the brake controller.
If it does not have a trailer... view full answer...
The tri-ball mount, # PS80425, will fit in a 2 inch trailer hitch receiver opening. If you have a 2 inch hitch on your 2008 Infiniti QX56 then this ball mount would fit the hitch. It measures 8 inches from center of the hitch pin hole to the center of the 1-7/8 and 2 inch balls and 6-3/4 inches to the center of the 2-5/16 inch ball. You will need to make sure these measurements clear the rear bumper of your QX56.
You will also need a hitch pin or locking hitch pin if you do not already... view full answer...
This Thule Force # TH6359B, would be mounted on the factory cross bars of your 2011 Infiniti QX56.
If you have rails that run front to back without cross bars you would first need to get the Thule Evo Raised Rail Feet # TH710401, 53" WingBar Evo Crossbars # TH711420, as well as locks # TH450400.
Once you have those installed you could install the roof box onto your QX56, and haul your luggage and baby strollers. view full answer...
Hi Rick; thanks for the question and the info you provided, and the answer is yes, you can absolutely convert from electric brakes to disc brakes. Disc brakes give you the best overall stopping power, so it's something I definitely recommend. For a 7,000 lb axle and a 5-bolt mounting flange I highly recommend DeeMax brakes:
- DeeMaxx Disc Brake Kit # DE53YR
You'll need two of the # DE53YR for your tandem axle trailer, and the reason I like DeeMax is not only their superior rust resistance... view full answer...
Go To Results