Cables instead of chains are a good idea if you don't plan on using them often, or have them "just in case" because they are a more economical option, and I can confirm for you that the Glacier Cable Snow Tire Chains # PW2029C you asked about do fit your 245/55-19 tires.
Tensioners will give you a nice tight fit, and for an economical option that will work I recommend the Glacier Rubber Adjusters # PW99.
I have added a link below to a video review for you to check out as well of the Glacier... view full answer...
As long as the side-view mirrors on your 2013 Ford Edge have a gap between the mirror and the mirror housing, the CIPA Clip-On Universal Towing Mirrors, # 7070, will fit. This is a universal mirror that was designed to fit many different mirror styles and after doing some research on your vehicle, I do not believe you will have any problems with this mirror. These mirrors have clips that will grip the mirror housing and secure to the mirror using rubber straps.
Another mirror that you... view full answer...
The correct wiring for your 2019 Ford Edge ST is the T-One Vehicle Wiring Harness # 118805. This is the only wiring harness we've verified to work with the ST model.
I also recommend picking up the brackets # 18144 and # 18140 so your 4-Way can be located next to your hitch receiver. view full answer...
Installing a trailer hitch receiver on your 2020 Ford Edge will absolutely not interfere with a camera on the lift gate in any way at all. The best option for a hitch for your 2020 Edge is from Curt, because it is the easiest installation, the Curt Trailer Hitch Receiver # C13234.
If you are going to be towing with your Edge and need a 4-flat wiring harness, the correct part will depend on if you have a Titanium model or not.
- Non-Titanium: T-One Vehicle Wiring Harness with 4-Pole Flat... view full answer...
I can understand not wanting to drill holes to mount a hitch, though the Draw-Tite # 75728 is only a fit the Sport model and will be unable to fit your 2014 Ford Edge SEL. I did double check with the manufacturer for you just to be certain. So to add a hitch to your '14 Edge SEL you will need to drill 17/32" holes in your frame rails for installation.
Drilling to install a hitch is something that is pretty frequent and a lot of people do, even in areas there is bad weather, and you can... view full answer...
Yes, the Malone RunWay # MPG2142 has been tested and confirmed to fit on a 2011 Ford Edge by Malone. This has a weight capacity of 33 lbs per bike (for a total of 99 lbs) so I do recommend checking the weight of your bikes as all other bike rack options are going to be very similar (maybe up to 105 lbs).
This bike rack doesn't come with locks but you can add them using the Thule Passive Security Strap # TH533 and the LoopLocks Cable Lock # MPG2168.
You may also be interested in the Softride... view full answer...
We have a variety of roof rack options that fit your 2017 Ford Edge with the glass roof but I really like the Yakima JetStream system because it's fine-tuned to fit your vehicle like a glove and keep the crossbars level with each other. The correct parts will depend on if you have the flush rails or a naked roof.
Flush Rails
50" JetStream Crossbars - # Y00425
SightLine Towers - # Y64AR
SightClip Fit Kit - # Y79AR
Naked Roof
60" JetStream Crossbars - # Y00426
BaseLine Towers - # Y28TR
BaseClip... view full answer...
The Draw-Tite Max-Frame Trailer Hitch Receiver is confirmed to fit your 2020 Ford Edge Titanium with hands free liftgate. Keep in mind, this will likely limit the functionality of the kick sensor so you will need to find the right spot on either side of the receiver to activate it. The same is true for any hitch you choose to install on your vehicle.
Also yes, the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # C73FR is the correct wiring harness for the Titanium.... view full answer...
Thanks for the additional information! I have a solution for you but the Kodiak K3 crossbars you have are obsolete and incompatible with current roof rack systems. I did some looking online and I wasn't able to find any replacement parts or information about whether or not the company had been bought out. You're going to need to replace your crossbars and upgrade to a newer system on your 2018 Ford Edge. The good news is most kayak carriers are compatible with all aero bars on the market.... view full answer...
Yes, you will want to use a wrench to attach the Wheel Masters Tire Pressure Valve Extenders item # WM8029135. These will need to be snug on the valve or they will come off when you're driving down the road. They have an o-ring inside that will crush. I have linked a video below of one of our installers attaching a different angled valve extender on an RV. view full answer...
While we haven't tested it to know for sure, I can tell you how to determine if the hatch on your 2015 Ford Edge will be able to open when you have on the Yakima SkyBox NX 16 Roof Cargo Box # Y95AV.
All you need to do is measure from the center of the front crossbar on your Ford to the edge of the hatch. If that measurement is at least 47 inches you will be able to open the rear hatch of your '15 Ford Edge when you have the Yakima SkyBox NX 16 Roof Cargo Box # Y95AV installed. view full answer...
Thule does show the Passage 3 trunk mount bike rack, # TH911XT, as a fit for the 2008 Ford Edge which means they have tested it and determined it is safe for use. However, if you notice anything that is cause for concern with fit or the security of the rack then I would stop using it. We have not had complaints about trunk mount racks and the Ford Edge.
If you will be carrying womens, childrens, or alternative frame bikes I recommend using the bike adapter bar # TH982XT for greater ground... view full answer...
The 4-Way to 5-Way adapter, # 47515, will work well on a 2013 Ford Edge and will not short out the vehicle electrical system if installed correctly. Installation is straight forward. The 4-Way on the vehicle plugs into the adapter. The blue wire then will connect to a reverse light wire on the vehicle using the included quick splice connector.
This adapter is not circuit protected so if there are shorts on the trailer they could back feed to the vehicle. Make sure the trailer wiring is... view full answer...
We do have all the parts needed to install a Yakima roof rack on yoru 2016 Ford Edge with a panoramic sunroof, and the parts are all sold individually, the crossbars, towers, clips and locks (if you want to lock the rack to your car). Here is a list of the parts you will need:
- Yakima JetStream Crossbars # Y00426 (Black)
- BaseLine Towers for Yakima Crossbars # Y28TR
- BaseClip Fit Kit # Y06139
- BaseClip Fit Kit # Y06102
- Same Key System Lock Cores (Optional) # Y07204
I have added... view full answer...
The Thule OutWay bike rack # TH65JV is not a fit for the 2017 Ford Edge Titanium but there are several 2-bike trunk mount racks that you can use.
You can use the Yakima FullBack, # Y02634, or the HangOut, # Y02637.
If you will be carrying any bikes that do not have a top frame bar that goes straight across (like a typical men's bike would) then I recommend using bike adapter bar # 64005. This will allow you to carry those bikes more level and will provide better ground clearance. I have... view full answer...
I have a great setup for you. Unfortunately, the RidgeClip fit kit Y06028 will not fit the 2021 Ford Edge. The parts that attach your vehicle depend not only on the year/make/model of your vehicle, but also what brand you use. Also, as is the case with the 2021 Ford Edge, If you want a complete roof rack system on your vehicle, here are the parts you need:
- Thule WingBar Evo Crossbars - Aluminum - Black - 53" Long - Qty 2 # TH711420
- Evo Clamp Feet for Thule Crossbars - Naked Roofs... view full answer...
Since you are dealing with a ground clearance issue with your tow vehicle and trailer, your best bet is to look into a short weight distribution shank like the Blue Ox shank, # BXW4017. This will provide the most ground clearance possible for your application. In addition to this shank, I recommend the Equal-i-zer Weight Distribution system. There is no weight distribution system that will provide the necessary drop and ground clearance that you will need, but these two components will... view full answer...
The Thule Gateway you referred to, part # TH88VR will indeed fit a 2011 Ford Edge. I have included a link to a video review and a link to the installation instructions for you. If you will be carrying women's, children's, or alternative frame bikes, I recommend using the bike adapter bar # TH982XT for greater ground clearance and to carry the bikes so that they are level. I have included a link to a video that shows how the adapter works.
To see other trunk-mounted racks that are a confirmed... view full answer...
Although Ford doesn't offer the option, there is an aftermarket hitch available for your 2013 Edge Sport, the Draw-Tite Class III, part # 75728. Going this route would allow you to use your Thule rack, if you still have it. If the rack was designed to be used in a 1-1/4 inch receiver, a reducer sleeve like part # HT02 is an easy solution that would allow you to continue using your rack.
If you're interested in a new hitch mounted bike rack, Thule offers the excellent Hitching Post Pro,... view full answer...
To use your 5th Airborne Premium Fifth Wheel Air Ride Coupler - 21,000 lbs Capacity # 5AB-E1621-610 on your Demco Hijacker AutoSlide you will need a capture plate. The Demco Hijacker Autoslide Locking Plate for Standard 5th Airborne Pin Boxes # DM6026 is what you need for this combination. view full answer...
Go To Results