Yes, the etrailer Hitch Pin Alignment Collar for Bike Racks # e98942 will work with your Thule EasyFold XT Bike Rack for 2 Electric Bikes # TH903202.
This collar is meant to work with any accessory and your 2" hitch. view full answer...
The Thule Motion XT in Black Glossy # TH629806 or Titan Glossy # TH629807 should fit and work just fine on the OEM roof rack you have on your 2013 Land Rover Range Rover Sport. These were tested to fit the Thule aero-style crossbars so as long as your crossbars aren't larger than 3-1/8" wide x 1" tall you are good to go.
Typically the biggest advantage an aftermarket roof rack has over the OEM is weight capacity. OEM roof racks usually have a lower weight rating so upgrading to aftermarket... view full answer...
There is a weight distribution hitch you can use with your nearly 3,000 lb GVWR trailer, though I do have to mention that the owners manual of a 2016 Ranger Rover Sport says it is not recommended to use a weight distribution hitch with this vehicle. But if you decide to, what you can use is a hitch from Fastway:
- Fastway e2 Weight Distribution w/ 2-Point Sway Control # FA92-00-0600
The Fastway # FA92-00-0600 is for total tongue weights between 200 lbs and 600 lbs, which is right in line... view full answer...
Yes, the Curt trailer hitch will absolutely fit your 2021 Range Rover Sport with a full-size spare tire in the floor of the cargo area; the correct hitch is the following:
- Curt Trailer Hitch Receiver # C13243
The only issues in regards to a full-size spare on a '21 Range Rover Sport is if it was mounted underneath the vehicle. Even then, the hitch would still fit but the spare would have to be stored elsewhere. But since your full-size spare is stored in your cargo area you will be... view full answer...
I checked with Curt and they do not list any exclusions for the diesel versions of the 2016 Land Rover Range Rover Sport with a diesel engine for their hitch part # C13243 so it would fit and work well.
There is no drilling or fascia modifying to install this hitch either. You will need to remove a panel but it can easily be reinstalled once you remove the hitch. view full answer...
The Rhino-Rack RSP Roof Rack # RSPT508 that uses the Vortex Aero crossbars is confirmed, by Rhino-Rack to fit all models of the 2012 Range Rover Sport as long as you have the factory installed tracks that run front to back.
The rack installs in the Rover's factory mounting points.
On the other hand if your Rover has a completely naked roof you can use Vortex Aero Crossbars # RRVA137B-2, the Track Mount RLTP Legs # RLTP, the RT-Style Tracks # RTS508, and Leg Adapters # RRVA-FK1-2. view full answer...
The Camco UltraGuard Slide-In Camper Cover - 19-1/2' Long # CAM45773 will have some slack in the width and length to cover your side jacks. The overall width of your camper is 97 inches, so you will have 5 inches of width extra. You will also have about 24 inches of additional length based on the manufacturer measurements, so when you also account for that you will have no problem covering those swing out jacks as well. The hold-down straps that are integrated will need to be secured... view full answer...
The Curt T-Connector Vehicle Wiring Harness for Factory Tow Package - 4-Pole Flat Trailer Connector # C56293 you were looking at for your 2018 Land Rover Range Rover Sport Supercharged is designed for vehicles with the factory tow package. If you do not have the factory tow package then you will need to take your vehicle to your local Land Rover dealer and have them install the necessary components to activate the tow package.
I included a video of the # C56293 for you to take a look at. view full answer...
I checked with the manufacturer and can confirm for you that yes, the T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector # 118275 is a fit for your 2016 Land Rover Range Rover Sport with a supercharged engine. This connector is a fit for all models of '16 Range Rover Sport.
I have added a link to the instructions as well as a video review for you to check out of the T-One Vehicle Wiring Harness # 118275. view full answer...
The Yakima SkyBox 21 Black Carbonite Rooftop Cargo Box # Y07337 does indeed mount on aero-style roof rack crossbars like the ultra-quiet Thule WingBar Evo bars # TH711520. It will in fact fit any crossbar that does not exceed the dimensions 3-1/2 x 1-11/16-inches and that are spaced apart (bar center to bar center) between 24- and 42-inches.
This black bar set, along with the Evo Clamp Feet # TH710501 and the vehicle-specific Fit Kit # TH145116 make up the Thule WingBar Evo rack system... view full answer...
For your Pedego Stretch electric bike I recommend the the Yakima OnRamp Bike Rack for 2 Electric Bikes - 2" Hitches - Frame Mount # Y36FR has a maximum wheelbase of 50" and weight capacity of 66lbs per bike but drops down to 40lbs if you're hauling off-road or by RV. view full answer...
There is one option for a roof rack that will fit your 2013 Land Rover Range Rover Sport that attaches to the factory track fixed mounting points on your vehicle. The rack is from Inno and consists of the following parts:
- Inno Aero Crossbars # INXB145-2
- Inno Through Feet for Aero Crossbars - Fixed Mounting Points # INXS350
- Custom Fit Kit # INTR112
I have added links below to instructions and a video review for you to check out as well. view full answer...
As long as your spare is not a full size spare that is the same size as the wheels and tires on your 2008 Land Rover Range Rover Sport then it will still mount in the factory location. If it is a full size spare then it will not fit and the only recommendation I can make for you would be to try and track down a smaller spare. view full answer...
Here is the mounting bracket # 18138 you need for your 7-Way Trailer Connector # 118275. This can be zip tied to your hitch or you can use self tapping metal screws to get it secured. view full answer...
The Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" # 13456 is the only confirmed fit we currently have for your 2010 Land Rover Range Rover Sport Supercharged. This hitch will work with the donut spare tire, but will not work with a full size spare tire. You have a full size spare tire, so it would need to be relocated for this hitch receiver to be installed.
The size of the spare tire will be restricted by width and not by height. I've attached a photo for you to see the... view full answer...
According to Draw-Tite, their # 75229 Class III hitch is a fit for all models of the 2020 Land Rover Range Rover Sport, including the Hybrid. If you'll be using the hitch for towing, you'll need a few other items to complete your towing system.
For a trailer wiring harness, use part # 118275 if the vehicle is equipped with the factory tow package or # C59236 without the factory tow package. For a ball mount, use # D-28 with the # PC3 hitch pin and either the # 19260 for a 1-7/8 or # 63845... view full answer...
The Tekonsha Plug-In Wiring Adapter part # 3035-P may work with your 2018 Land Rover Range Rover Sport HSE. However, the pins inside the vehicle side brake controller adapter port may not match that of the above harness. The reason for this is that the different trim packages all use the same brake controller adapter port, but they are not all pinned the same. This means that the 12 volt power wire on the vehicle side could align with the 12 volt power wire on the brake controller side... view full answer...
The Hopkins wiring harness you looked at, part # HM43534, actually fits some Nissan vehicles that have the factory tow package.
If your 2011 Land Rover Range Rover Sport didn't come with any factory trailer wiring you need a universal harness like part # C59496. Then you can convert that 4-way to a 7-way using our # ETBC7 kit. This kit is designed to work with the Curt Echo brake controller, part # C51180, because it doesn't need the additional wire ran to the Rover's cab. The install... view full answer...
According to page 221 on your owner's manual. A set of tire chains can only be installed on the rear wheels if they are 19" in diameter. They can however be installed on the front wheels if they are 20" in diameter. Per the manual, before using a set of tire chains on your 2010 Land Rover Range Rover Sport you must first disable the Dynamic Stability Control (DSC) system and not exceed 30 mph.
Therefore, I can only recommend that you use the Konig Premium Self-Tensioning Snow Tire Chains... view full answer...
We have many tire chains that will fit your 2018 Range Rover Velar. The Konig Premium Self-Tensioning Snow Tire Chains - Diamond Pattern - D Link - K-Summit XXL - Size K77, part # TH02230K77, that was attached to your question will fit your 255/55-20 tires. These tire chains are also my recommendation, they are the only one compatible with your 2018 Range Rover Sport that offers wheel protection. These tire chains are Class S Compatible, so they are designed for vehicles that do not have... view full answer...
Go To Results