The breakaway kit that would be on a drum brake setup is different than what would be needed with a Dexter Electric Over Hydraulic setup # K71-651.
The correct breakaway you would need is the part # 34-285 which is designed for use with the Dexter actuator. view full answer...
The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached a help article on determining tongue weight for you to check out as well. You will want the loaded tongue weight of your setup to fall right in the middle of the tongue weight range of the system you use.
So assuming your tongue weight is... view full answer...
Yes, the two Torklift camper tie downs part numbers # TLC2204 and # TLC3206 are correct for your 2007 GMC Sierra 2500 long bed without boards and a factory hitch. view full answer...
I highly recommend the Tekonsha Prodigy P3 # 90195 with the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers # 3015-P for your 2007 GMC Sierra Classic 2500 HD Diesel.
The Tekonsha P3 # 90195 is a top of the line trailer brake controller that is extremely reliable and will be more than capable to control the braking for your three horse Trails West Classic Warmblood Trailer . This controller will work with trailers up to 4 axles, offers an easy to read LCD screen, and a built... view full answer...
According to my research, your 2017 Forest River Rockwood A214HW Camper has Dexter Torflex Torsion Axles. I looked up the weight capacity of your axle and seen it was 2,300 lbs which means the Torflex Lift Kit part # K71-707-01 should be what you need.
This kit will provide you with a 2-5/8" lift but please keep in mind it is not recommended for use on torsion axles with 3" high profile brackets. view full answer...
To install a 4-way connector on your 2007 GMC Sierra I recommend the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector # 118384. This will plug into the round black connector on your truck.
I included a video of the # 118384 being installed for you to take a look at. view full answer...
I would recommend you get a Derale Thermostatic Sandwich Adapter # D25782 as it comes with multiple adapter sizes to ensure that you get the correct size for your application.
I did some checking and it looks like you will need the 22 mm x 1.5 mm size for your 2007 GMC 3500HD. This is one of the included sizes in the # D25782. However, since you said you have a LBZ engine and I was under the impression that the 2007 trucks had the LMM engine the # D25720 would be a safe recommendation... view full answer...
The Happijac tie down kit part # LC182906-182971 does for sure fit your 2007 GMC Sierra Classic 2500HD and the # TLS9520-22-LK Torklift Locking Fast Gun Turnbuckles for Bed-Mounted and Frame Mounted Tie Downs will work with them as well. view full answer...
The Curt Spectrum # C51170 is definitely a good choice for your 2007 GMC 3500. This is a great proportional controller, and is more reliable than a lot of the wireless or Bluetooth compatible controllers that Curt makes.
It is also a good controller to use with larger trailers as it can control brakes on up to 4 axles if needed. It will have a much cleaner look in the cab with the LED control knob.
Your Truck should already have brake control wires run under the dash. You can use the... view full answer...
You can back up with the Pro Series Weight Distribution System # PS49901 but only if you are backing up in a straight line. If you have to turn the trailer tightly at all while backing up you would need to disconnect the spring bars and the friction sway control unit as they will get damaged if the trailer is turned too hard. view full answer...
Yes, the Curt hitch part # C15312 that you referenced does fit your 2007 GMC Sierra Classic dually that has frame dimension of 42 inches from outside to outside on your truck frame. view full answer...
I attached a picture that shows what the Rearview Safety Camera part # RVS-83112 would look like in a similar situation looking down from on top of a truck cab onto a fifth wheel hitch head. This would be very similar to an Andersen Ultimate like the # AM3200. view full answer...
For your 2007 GMC Sierra Classic 3500 and Reese 5th wheel hitch/accessories I recommend custom brackets and hardware # RP50064. The custom installation kits require less drilling and install quicker than universal or semi-custom kits. I have included a link to a video showing an example installation for you. view full answer...
For a heavy duty plow setup the first thing you'll want is a plow that attaches to frame brackets that fit your 2007 GMC Sierra 2500HD Classic and not a front hitch as the front hitches mounts just aren't quite as sturdy.
So the best option for your needs is the SnowBear Winter Wolf Plow part # SB324-116 as it's the largest (88 inch by 26 inch), has the most adjustability, and overall is the most heavy duty setup around for your truck. For a set of brackets designed for your truck's frame... view full answer...
Since the install of the Roadmaster Comfort Ride Leaf Spring Suspension Kit w/ Shock Absorbers # RM-2460-2560 uses the existing hangers on the trailer for the very front and very back a set wheelbase isn't stated with this kit. Basically you'll end up having a very close wheelbase to what you have now. view full answer...
Based on my research, your 2017 Rockwood A215HW does indeed have electric trailer brakes. So for your 2007 GMC Sierra, since you have the towing package with the factory 7-way, all you will need is a trailer brake controller and the correct wiring harness. For the brake controller, I highly recommend an option from Draw-Tite:
- Brake EVN Trailer Brake Controller # TK63VR
I love the Brake EVN because it is a great value with its unique combination of quality and cost-effectiveness. This... view full answer...
The ST235/80R16 has an outer diameter of 30.9 inches whereas the ST205/90D15 has a diameter of 29.5 inches so the diameters are pretty close. They would be close enough that there would be no issue going from one size to the other. For that you could use the part # LHACK133 for this size mounted on a wheel with a 8 lug bolt pattern or part # TA59VR for a 6 lug bolt pattern.
Worth mentioning is that the tire size you have now isn't a standard trailer tire size and it's not recommended... view full answer...
Double kitchen sink # 277-000089 is measured based on the outer edge or overall length and width. So the hole that it fits in will need to be slightly smaller than 29-1/4" x 18-1/2". That should fit what you have perfectly. view full answer...
For your 2007 GMC Savana Van I recommend the etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class IV - 2" # e98861 as it has a very durable matte black powder coat finish to resist chips and scratches, and has a 1000lb tongue weight rating and 10000lb trailer weight rating which is perfect for towing or carrying a bike rack or cargo carrier.
Keep in mind this hitch and all of our available hitches will only fit the cargo and passenger models, not the cutaway chassis... view full answer...