To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Low-profile, aerodynamic crossbars create an aftermarket roof rack for your vehicle. Aluminum bars have T-slots that let you mount channel-mounted carriers and accessories. Flexible rubber strips in T-slots keep out dirt and won't need trimming.
Features:
Inno Aero Aluminum Load Bars - Black - Qty 2:Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today on our 2016 Ford Edge we'll be taking a look at Eno Arrow crossbars. The part number for our crossbars today are INXB115-2, for our flush feet we're using INSS200, and for our custom fit kit for the Ford Edge we're using INK676. These crossbars are a low profile aerodynamic design which will help to reduce wind noise and drag and will allow you to carry any roof-mounted accessories on top of your vehicle. This works with either channel-mounted or clamp-on accessories. The weatherstripping on the inside easily pushes down to adapt for those channel-mounted accessories as well as to help keep dirt, debris and liquid out of your crossbars when you don't have any channel-mounted accessories loaded up. All pieces of the roof rack kit come with a limited lifetime warranty and the crossbars have a 165 pound weight capacity. Here, everything we have on our table is what is included in our kit. We've got our foot pack with our locking cover.
The hardware that the tools that we'll need to secure this to our bar. Our crossbars here. Our fit kit that will be custom for our Ford Edge. The only thing we needed to provide was a flat tape measure. To start our install, we're going to slide this portion here out until it comes all the way out on the end. Then we'll take our metal bracket and we're just going to stick it up underneath and then sliding that piece back in so that it is all in the way in this section here.
That will help us to connect our foot pack to our crossbar. To get our foot pack ready we're going to start by removing our bolt here. We're going to remove the washer with that. We'll take our metal clamp and loosely set that on top and start to tighten down our bolt once again. We don't want to tighten it too much. We still want it to be loose so that we can fit this onto our roof. We'll flip our foot pack over, take our rubber bottom and this is going to secure to the bottom of our foot pack.
Next, we'll take our foot pack and we're going to secure it to the bracket here. Our foot pack is going to slide on top and then slide all the way down to the end of our crossbar. Our measurement for the distance between our two foot packs is going to be 111.5mm. That's going to be from the center of our foot pack to the center of our foot pack. Now we'll take the larger Allen key and we're just going to tighten down the bolt on the inside. This is going to insure that our foot pack stays in this position.
We'll do the same thing to the other side. Now I'm ready to open up our vehicle doors and load this up. I'm going to take our crossbar and make sure that the fatter side is facing towards the front so you get that nice aero shape. We're just going to place this around our vehicle. Now we'll measure our crossbar spread. This is going to give us the correct placement for our rear crossbar. We're actually going to measure from the center of our weatherstrip here between our two doors. Our measurement should be 48mm. We'll measure the other side. With those in place we'll take our included torque tool and we're just going to tighten down this bolt here. We're going to start by tightening it down so that the clamp fits just up against our door jamb here. We'll do the same thing to the other side. Now we'll go back and forth doing about 5-10 turns on each side until it's completely tightened down. When you hear that clicking noise that's when you know you have enough torque behind the bolt and it's completely secured down. We'll do the same thing to the other side. We've got both sides completely tightened down and our door is closed. We're going to take our locking end cover and lock that into place. That's going to help prevent theft and tampering of your crossbars and any channel-mounted accessories that you may have. Now we're ready to load up our gear and hit the road. That's going to be our completed look at the Eno Arrow crossbars for our 2016 Ford Edge.
Average Customer Rating: 4.8 out of 5 stars (96 Customer Reviews)
Low-profile, aerodynamic crossbars create an aftermarket roof rack for your vehicle. Aluminum bars have T-slots that let you mount channel-mounted carriers and accessories. Flexible rubber strips in T-slots keep out dirt and won't need trimming.Aero roof rack is very stylish and gives my car a good look. It’s low profile look is what I really enjoy about it. The bars are pretty wide so any bars you do add to them, you’ll have to do IN-DEPTH research to make sure they do fit. I’ve had some run in with some issues with bike racks
I bought these last summer to affix my kayaks to the roof of my corola. my husband, who is decidedly not a handy person, installed them in an hour and they've been great. no issues– slight whistling at times on the interstate, but that's to be expected. highly recommend!
Great profile. Looks good on truck.
Locking and unlocking very easy.
2016 Golf R MK7
Love it so far
Thank you etrailer my car looks great I spent 4 hours to ensemble this cross bar and the bask rack but finally I made it now I have more cargo space in my car I really recommend etrailer good quality items and good service thanks again
The roof rack arrived days before it was scheduled to. Everything ordered arrived intact. Assembly and installation were pretty easy per the directions included and the video on the etrailer site. The rack looks fine on my Maxda CX5 and the additional noise from the rack is not too bad. Haven't had my cargo box on the rack yet but anticipate no problems with it. My experience with etrailer has been first rate.
Josh is the greatest! Thanks for all the help!
Needed to purchase some longer bars for my system. This product fit the bill, was more affordable than other options, and the team at e trailer will always be there to help should I ever need assistance. This was for my wife's Ford Edge c ok company car. Now she has a Traverse so we will be purchasing new feet, but can still use the bars. I'd reccomend them for any need you have in the categories they offer. I'm a 4 time customer and will use them for all my rack related purchases.
I bought this for my 2016 Fiat 500X which has two glass sunroofs, and it fits perfectly! Follow the directions, put the bars where it says to, and your glass will be safe. You can't open the sunroof while this is in place, but hey, at least you can haul gear on your roof without breaking the glass.
Everything about this kit met my expectations.
- Perfect fit for my Ford Edge, as advertised.
- Lowest bar height that was still high enough for the Edge Vista roof to clear. The glass does clear when nothing is attached to the bars.
- Aero bar shape. I haven't done a lot of miles yet with only the bars and no other attachments.
I attached an Inno roof box (which still fits through my garage door!) and did a 2000 mile road trip at insterstate speeds. Except the box noise (expected), and a bit of a mileage hit, I had no issues. Secure fit the whole way.
We recently purchased 2 kayaks & Thule roof racks from our local outdoor store.
After waiting 2 weeks for our roof racks and J bars to come in we found that the Thule racks did not fit our 2017 Lincoln MKX and they didn't make any racks that would. The vehicle does not have roof racks and has a moon roof.
After a couple of days searching the internet we discovered etrailer.com. We found the Inno roof racks, but still was not sure they would work. We spoke to a repesenative and he assured us that the racks we chose would fit and the Thule J bars we did return would also work. As you can see by the photos 2 days later we were happy Kayakers.
By far the best service I have received in a very long time. I recieved my inno flush feet areo crossbars, sooner than expected and the assembly was just as specified. I especially liked having the video with the tutorial.
I like the look of the low profile and the quality is outstanding. I have used this for my kayak and the low profile helps with the loading and unloading.
I would highly recommend this product and Company.
I bought the whole kit for 2008 honda fit for a cross-country trip, and it performed great. Made it with two surfboards on top with no problems. Instructions for installation are atrocious, but youtube videos can fill in the gaps. Shipping was quick. I didn't use any of the customer service options, but it seems like they would be useful if needed.
Very happy with purchase. This third rack system I have purchased ( for different vehicles) and first Inno system. Seems every bit the quality of my Yakimas and like the attachment portion to roof rails, everything is coated so no possibility of scratching paint on car. Delivery was very quick and Etrailer price matched Amazon!
I like that the feet don't extend too much beyond the width of the vehicle (2012 Toyota Prius V). No noticeable wind noise or fuel economy change. They held two bikes just fine. The tightening process feels very secure, but took me a while to do. I wasn't in a hurry so it was fine.
The Inno racks have handled an assortment of different loads without problems. They are quiet at highway speeds. The lack of tie down points are the only drawback with these racks.
fast shipping, great customer service, and easy to install
They were so helpful. Geoffrey got me the parts the next day and the roof rack works great. Easy assembly. Just needed a little muscle power to click the final pieces together. Everything else was an easy bolt.
Easy and worked well with the total kit for our vehicle. Feel sturdy and strong. We’re happy with them.
Shipping and packaging was very good and delivered on time!
Love the flush bar look!
Great product and figment, the service was great as well, the only suggestion I have is if there is a product that cannot be shipped to Canada it should be told when you try to order it, however the follow up call was appreciated .
The entire process was Easy Peasy! Ordering,excellent packaging, and easy install! I couldn't be happier; my hat is off to this fantastic company!!
Easy install, build quality is really nice as is fit and finish. Almost no wind noise at highway speed.
Heavy duty and well designed feet. Love the locking feature, and instructions were clear.
Perfect roof rack for my car.
Do you have a question about this Roof Rack?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.