etrailer Bolt-On Swivel Mounting Plate for 3,500-lb Trailer Jacks with a 5/8" Swivel Pin

Video Transcript for Review of etrailer Bolt on Swivel Jack Mounting Plate - e52JR

Hello etrailer neighbors and friends, welcome back. I'm Steven with etrailer.com. Today we're taking a look at this etrailer bolt-on swivel mounting plate for your 3,500 pound trailer jacks with the five eighth inch swivel pin. Now this guy will basically bolt onto your trailer frame and then provide a mounting point for your pipe mount swivel jacks. So traditionally you have a pipe mount swivel jack. There is a little round tube like this maybe without this back piece, and you'd have to weld that piece onto your trailer to then mount the jack.

Well, maybe you don't have a welder, you don't want to weld. You don't know how to weld. That's where this guy comes in 'cause you can just simply put it over the top part of the frame, drill a couple holes, put the included bolts and hardware in, tighten that guy down, and now you've got your own pipe mount flange for your swivel jack. Now this will work with jacks up to 3,500 pounds capacity. You can also put this in different spots of your trailer.

So what I've done on my personal trailer home is I use the weld on ones, but I put the same concept at all four corners of my trailer. And I've got a little bitty trailer for my ATV. So it's pretty light, it's only maybe 2,000 pounds, but I can now move my jack if I'm still connected to my vehicle and maybe put my jack on the back corner, the right corner, the middle, whatever, and lift up that corner, let's say if I had a flat tire or something like that, or I just wanted to work underneath there, I could get a little more height and I'm only using one jack to do all of that. So it's pretty nice. I do recommend getting a couple of 'em if that's something that you're looking for.

Now the hardware is gonna fit the frames with a cross section depth of three inches or less. And the lock washers and nuts provided are gonna prevent vibration. And it's a nice durable steel construction. It's got a nice matte black powder coat finish and it's got an E-coat as well. It's gonna make it very corrosion resistance, very nice welds and everything there.

Very nice product. Now dimensions, so this overall diameter is two inches. The pinhole diameter are five eighths of an inch. That's standard size. The length from the plate out is two and a half inches. The plate itself is five inches wide and it's four and a quarter inches tall. And again, it's two inches deep. Now it does have a limited lifetime warranty. I do wanna zoom out here and pull up one of these jacks just as a demo only. So we got our side mounted swivel jack here. I'm gonna get this pin pulled out here. Now this is the part that I was talking about earlier. You typically weld this onto the trailer frame. This is gonna be replaced with this guy here, and that's what we're talking about today. So I'll put that guy down. Now this guy obviously is smaller than that. It's gonna fit inside. So you simply would have this mounted to your trailer and then just like that. Now you've got this here, you can mount it that way or same concept. If this was mounted to the trailer, you could swivel your jack. I'm just swiveling this one for demonstration purposes. You could swivel the jack and then voila, you've got that up on the trailer. So kind of step outta the way with the white background, give you a better look at that. But that's what it's gonna look like on your jack. Alright, I'll put all this back here real quick. Again, this mount is gonna make it really easy to mount that style of jack. Again, you're getting the mounting bracket and all the hardware required for that swivel jack. Well, folks, that's a lot of information. I hope it's been helpful. I, again, I'm Steven at etrailer.com. Thank you so much for your time. Thank you for looking with me today at this etrailer bolt on swivel mounting plate for your jack. Have a great day.