Summer Starts Here - Save up to 70%
Customers prefer these similar products
26" Wide x 18" tall x 2-3/4" deep, high-powered, dual, electric fan assembly will boost your vehicle's fuel economy and increase torque and horsepower. Aluminum shroud is rustproof and can be painted, polished or anodized.
Features:
Specs:
Whereas belt-driven fans use up power from the engine to turn, electric fans do not, thus removing any unnecessary load and increasing both fuel economy and horsepower. In addition, you do not have to worry about an electric fan's slowing down at low RPM, as many belt-driven fans do, so you are guaranteed sufficient airflow regardless of the vehicle speed.
While this assembly is intended for primary cooling and should, therefore, provide enough CFM to replace your vehicle's factory fan, you will still need to determine the CFM requirements for your engine before making your purchase. And remember, engines that have been modified or vehicles often used for towing may require additional CFM. There is no limit to the number of fans you can install, as long they all fit appropriately and are mounted on the same side of your radiator so that they do not cancel each other out.
Two types of turn-on sources are available for this fan. The Derale Lighted On/Off Switch for Electric Fans (D16740) allows for manual control of your fan so that you can choose when to turn it on and off. Thermostatic controls, on the other hand, send a signal to the fan, directing it to shut off when fluid temperatures reach an appropriate level, thus saving power. Once the temperature climbs again and additional cooling is needed, the fan is automatically turned back on. Thermostat switches can be single-stage with pre-set temperatures - D16735, D16738, D16739, D16720 and D16721 - or adjustable - D16788 and D16789.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to look at the Derale 26 inch dual high output electric radiator fan with the aluminum shroud assembly. Now belt driven fans will use up power from your engine to turn the fan. Whereas electric fans will not, so that removes any unnecessary load, and increasing both your fuel economy and your horsepower. Also, you don't have to worry about an electric fan slowing down at low RPM as a lot of your belt driven fans do. So you're guaranteed sufficient air flow regardless of the vehicle speed. Now this whole assembly here will improve your overall performance of your vehicle.
It has the patented ultra quiet skewed blade design. You can see here. It is designed with this nice durable, rust proof aluminum shroud that can be painted, polished, or anodized to fit your application. I'm going to turn this around here so you can see it. It will effectively vent air and pressure in the engine compartment with these built in relief flaps right here. Now this can be mounted in various locations on the engine side of your radiator.
It is a polar application only. It does come with everything shown here on the table: the aluminum mounting brackets, the rubber fan shroud seal, the mounting hardware, and a nice set of detailed installation instructions. This part is made in the USA. Now to turn this fan on, there is two types of turn on sources that are available for this fan. The Derale lighted on and off switch for this fan, it's part number D-16740.
We sell it separately on our website. It will allow for manual control of your fan so that you can choose when to turn it on and off. Then they also offer thermostatic controls, which will send a signal to the fan directing it to shut off when the fluid temperature reaches an appropriate level, thus saving you power. Then once that temperature climbs again, and additional cooling is needed, the fan is automatically turned back on. Now the thermostat switch is going to be single stage with preset temperatures, or they can be adjustable.
Now Derale does offer many different choices, and we do list them on this product page as related products. A few specs on this. The overall dimension, I'm going to give you the overall width of this from one end to the other is going to be right at 26 inches. The overall height from the bottom to the very top is right at 18 inches, and then the depth of it if we put the tape measurer on it you can see it's going to be right at 2 and 3/4 inches deep. Now this does have a maximum cubic feet per minute of 4,000. The power draw is 24.8 amps per fan, and it has high output motors that are 300 watts. That should do it for the review on the Derale 26 inch dual high output electric radiator fan with the aluminum shroud assembly.
Do you have a question about this Radiator Fan?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.