Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Replaces 1 pad for your SnapPad jack stand pad system. Pad increases the surface area of the jack foot to help prevent sinking and provides added stability. Fits 9" round jack foot.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everybody, Andy here with etrailer.com. And today we're gonna take a real quick look at this replacement pad for your SnapPad jack stand pad system. So this is going to replace one pad for your jack stand pad system. And this is designed to fit your nine-inch round jack foot. And let me turn this onto the other side here and just give you some overall measurements. So looking at the diameter, as you can see, we're sitting right at 11 inches in diameter.
And the overall height, we're sitting right at two inches. And I weighed this earlier. and this weighs right at five pounds. So if you're looking for a replacement SnapPad jack stand pad for your nine-inch round jack foot, this is going to be what you need. That's gonna conclude our brief look today.
I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.
Average Customer Rating: 4.8 out of 5 stars (4187 Customer Reviews)
Replaces 1 pad for your SnapPad jack stand pad system. Pad increases the surface area of the jack foot to help prevent sinking and provides added stability. Fits 9" round jack foot.
I gave up using them because especially the back ones kept falling off. Because they are cushiony it makes the 9 inch metal jack feet bend upward around the edge/mushroom upward. And the snap pads fall off.I
I had SnapPads on our Fifth Wheel and liked them, Ordered replacements for our MH after the Dealer installed ones fell off on the first trip. They did not work out either. Everyone said they were the correct one for our MH but they would not stay on. Not an E Trailer issue but a Manufacturer issue.
Katrina D.
2/12/2024
Sometimes, the feet of the trailer jacks will bow, which can cause the pads to not stay on. When we see repeated losses, it's most commonly from the trailer jacks feet have dished out (like a concave) over time of use. Another reason could be ground clearance issues when navigating curbs, speedbumps, and potholes. It could also be that that the lip of the pad was damaged during the installation process, the SnapPad cannot be guaranteed to remain intact. There a couple of other factors as well, I will send them in more detail to you via email.
etrailer was amazing who knew you need to tighten the bolts united the hydraulic leveling landing pad. So retuning from Mount Lassen California I lost the right rear landing pad. Who knew there was a bolt under the foot/pad that needs to be tightened once in a while. I was looking at replacing the foot and the attached Snap-Pad. I thought I would have to buy more Snap Pads than I needed to get just one and would have to buy at least two of the hydraulic landing foot/pad. But nooo!!! etrailer to the rescue they sold me just one landing foot/pad and one Snap-Pad. Wow! Someone who looks out for the little guy Thanks etrailer. Let me add everyone I talked to were kind and very helpful. Oh! Hint to keep it from happening again I used a dab of blue lock tight to keep the bolt from backing out again. Don’t know if it recommend but it’s my solution
As always Etrailer had what I needed at a reasonable price and quick shipment. as a full time RV'er and maintain several work trailers they are the go to place for me to keep everything in good operating order.
The link was very informative, and the product I ordered was shipped in a very timely manner. I have purchased items from etrailer.com in the past and will continue to do so. Great customer service, and follow up. Great job!
E-Trailer shipped the rv pad amazingly quickly! The product is constructed extremely and works as described on their website. Thank you again E-Trailer !
I am happy with the pads after pulling the camper cross country this summer. I lost 1 pad on the road shortly after installing. The replacement has been on all year and has worked well. I would recommend putting some soap on the pad to ease installation. Had I not lost the one pad I would have given 5 stars.
Stephen H.
10/7/2023
I have now lost 2 pads over 2 summers. I luv the product but will have to rate middle of the scale with losing half of them. I am going to Ron some stainless steel bolts through them and fasten to the hydraulic steel foot. I hope this prevents any more loss.
Mike L.
10/24/2023
Easy ordering and delivery. Item arrived in perfect condition. Appreciated attached install video to order.
Brad
11/1/2023
Great! Don’t even think about it. Worry free.
Easy to install. On the first trip, the left rear pad did not clear the curb, split and came off. I noticed it 10 min out after our safety check. I ordered another one and so far so good! The pads did not come off! I also raised the rear jack to clear the curb. These are a good investment, and help stabilize the RV. Should only have to purchase these one time!
Perfect fit for my new adjustable length front jack foot. Installation was easy - I used the stacked levelers in the picture to help guide the pad onto the foot by sliding support where needed to insure a good "snap" on all edges.
Goodbye wood blocks - with the larger diameter front jack foot and snappads on all things that touch the ground (also installed snappads on my stabilizer feet) my asphalt driveway will be happy!
Well, we have used the snap pads on the original 5th wheel trailer and also just switched them onto our new Flagstaff 5th wheel trailer and like them very much. Yes they were tough to remove off the older trailer but installed perfectly on the new one. ( I sell RVs and tell my customers how well they work. ). A very good product.
Purchase one because I lost it somewhere in my travels I’m sure by rubbing a curb!!!!
Great replacement for a lost pad.
Exact replacement !
Sturdy, solidly in place, after 35,000 km on the roads to Alaska and back, we can certainly confirm: great addition to our travel trailer! Much easier to set up and break down from sites.
Very pleased with this product, very durable and helps stability of jacks on ground. Would purchase again if ever needed.
Had 1 one pad out of 6 that deteriorated and fell apart. Ordered another and the same thing happened. Bad batch? I contacted them and got no response. Company recently emailed me for a review and I emailed them back expressing my disappointment and gave them a chance to make it right. Crickets.
Brooke M.
3/23/2023
I reached out to Snap Pad and they will be getting in contact with you, so keep an eye on your emails.
This is a replacement pad. Hit a piece of tire in the road and it took off one of my pads. E-trailer is always an excellent go to for any part I need. Went here first and was pleasantly surprised that I could buy a single replacement. Excellent customer service, excellent shipping while on the road traveling. Excellent communication.
We love the snap pads. We lost one recently due to a tire blow out.
This is the second pad I have replaced. The first was replaced under warranty by SnapPad.
This was purchased for a customer's repair. The part arrived quickly and this is the only source I have found for getting the single pad. Even our distributers do not offer it!
PUTTING THEM ON TODAY
I have always received excellent customer service when ordering camper items from Etrailer. I greatly appreciate the way the team communicates with their customers from the moment the item is placed to delivery.
Thank You!
I had a leveler go bad and the hydraulic fluid separated the pad in pieces and needed replaced. Having had them before , I quickly reordered a single pad. Received in short time and installed it easily. It is the only kind I will have on my motorhome. Great product.
You can use your auto leveler any where when these are installed.
Do you have a question about this RV Jack Pad?
Condition: Installed
Notes: Item has been previously test fitted and has minor wear.
Condition: Installed
Notes: Item has been previously test fitted and has minor wear.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Jenny N.
2/26/2024
I do know that on some of the newer Class A motorhomes that are heavier they use the 9 inch feet plates that can become concaved when used. They will not fail however it makes it near impossible to install SnapPads and keep them on. You can replace the foot plates with 12 inch foot plates and then use larger SnapPads with them, keeping in mind the that you will need 14 inches of full clearance around their retracted feet to allow for the diameter of the SnapPad. We are working towards adding this information to our site.