Replacement etrailer E Track Rotating Board Holder - Qty 1

Video Transcript for Review of etrailer E-Track - E-Track Cargo Organizers - e76HR

Hello everybody, this is Jeff at etrailer.com. Today we're gonna take a look at this etrailer rotating board holder for the E-track systems. Now this rotating board holder will let you create a shoring beam to secure large bulky items in your enclosed trailer. And to use this as a shoring beam which you'll need is a second board holder like this one and then a 1 3/4 inch thick board that would slide into here and then on your second one across the trailer or you can also create a shelf or storage rack using second board holder and multiple boards. Application, we mentioned this will fit into a horizontal or vertical E-track and X-track systems. And just to give you an idea, I wanna pull up section here to just show you how this installs.

But this is a section of E-track. You can see it has the multiple slots on this section. And we mentioned it can be used this position horizontally or vertically. This part here is probably better used in the vertical position, like if it was on a wall of your trailer or workshop. And the way you install it, it's pretty easy.

You just pull back the spring loaded lever, insert it into what slot you want, and you're all ready to go. So if we pull back on that slide it into the slot, drop it into place let the lever snap in, and then you got it installed. What's nice about it is the system is very easy to move it back and forth. It can easily be moved. If you wanna move it down a couple slots, pull back on the lever, lift up and releases it, hold it open pull it in the next one, drop it.

And just like that, you're hooked up. Simple as that. Now if you notice the holes on the sides both sides and on the bottom, if you want when you put your board in there you can secure it with screws if need be. Now this part is a steel construction has a nice yellow zinc plating on it which it makes it strong and rust resistant. Also, if you notice on the fitting right here, this slot this is a strap slot.

This will allow you to attach up to a two inch wide strap to this fitting. So if you need to put a strap to anchor a strap down it will go through here and you can use that. A few specs on this, give you a few measurements. Overall length from this end all the way to this end. If we get our ruler out, you can see it's gonna be right at about 5 1/2 inches. Now the holder itself the length on just that front to back, it's gonna be right about 3 1/2 inches deep. Overall width on it, outside the outside it's right about two inches wide, inside 1 3/4 inches. And the height on it it's gonna be right about three inches tall. But again, just to show you how this will install take our lever, open it up, hook it up like that. And just like that, you're ready to go. And then again, it'll rotate which direction you need and to remove it, pull back on it, lift it up and you're ready to go. But that should do it for the review on this etrailer rotating board holder for your E-track systems.