Summer Starts Here - Save up to 70%
Universal wiring harness powers 1 Vision X light or light bar. 10' Long harness includes 1 Deutsch connector, 2 ring terminals, and on/off toggle switch.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to review part number P-HARNESSXIL, this is the vision xwiring harness for single vision xlights. Now this universal wiring harness will let you run power to 1 vision xlight or a light bar, it includes a toggle switch right here to turn it on or off. This harness is a weather proof construction, includes this industry standard triple seal deutsch connector that connects the harness to the light or the light bar, gives you a nice weather proof seal. There is 10 feet of wire on the toggle switch which will allow you to mount the switch where you want to put it, has a 12 volt relay which is included, comes with the 2 inline 30 amp fuses, and all the wire they use is a 14 gage wire. So basically when you go and install this, here is your 12 volt relay right here, plugs into this plug right there where all the wires are coming out of, you mount that wherever you need to and then the wires coming out of it, this first wire here, when it comes out this would plug into your light or light bar, weather proof deutsch connector. The other wire that has a ring terminal on the same one would be a ground wire, so you do need to ground this to get a good ground. Now this other wire coming out of here will also need to be grounded, that's a ground wire for the relay and then this set of wires coming out with the fuse on it, this would run to your 12 volt battery and attach to the positive side of your battery to supply power right to here and then this other wire coming out is the 10 foot long toggle switch wire with the 30 amp fuse also in there and then the red wire coming out of the other side of the fuse holder would also need to be connected to the positive side of your battery. Then once that's all plugged into your light or light bar and all hooked up and wired correctly you'll be able to control your light or light bar by this toggle switch.
That should do it for the review on part number P-HARNESSXIL, the vision xwiring harness for single vision xlights. .
Do you have a question about this Accessories and Part?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.