Summer Starts Here - Save up to 70%
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to take a look at the anti-flicker harness for turn signals. Now, this part will allow you to convert incandescent turn signal lights to LEDs while still maintaining proper flash rate. On one end of this is a three-pin right angle male PL-3 plug, and on the other end you can see is the three blunt-cut strip leads. This does have a 25-watt rating, and again, this is for use with DOT approved lights, and one harness should be used for each of the four turn signals to the driver's and passenger side front and the driver's and passenger side rear. But, that should do it for the review on the anti-flicker harness for turn signals.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.