Reese Strait-Line Weight Distribution System Installation - 2003 Nissan Frontier Video

I think you'll need to go up a level in weight rating for your 5,000 lb GVWR Airstream travel trailer. The reason being the Reese Pro Round Bar Weight Distribution #RE34FR is for loaded tongue weights between 200 lbs and 600 lbs. I assume the 520…

I spoke with my contact at Curt regarding the Curt TruTrack Weight Distribution System #C17499 that you are installing on your trailer. He said that you can install the support brackets 6 to 6-1/2 inches from the end of the spring bar without issue.…

When it comes to choosing between the Curt TruTrack Weight Distribution System w/ Sway Control #C17499 and the Equal-i-zer Weight Distribution System w/ 4-Point Sway Control #EQ37100ET you'll want to take a couple of things into consideration: 1.…

You are definitely on the right track here. When it comes to weight distribution hitches, it all comes down to your tongue weight. All of these systems will have a range of tongue weights that you want to stay within for them to work effectively. I…

You definitely want to go with the Reese Strait-Line part #RP66074 that has a 1200 pound tongue weight for your travel trailer since your tongue weight will be over 800 lbs. When towing, if your weight distribution system is not rated high enough,…

Tilting the hitch ball on your weight distribution system is a final adjustment to get the trailer perfectly level and apply the correct amount of tongue weight. You need to make this adjustment, if needed, after the the vehicle and trailer are…

The "external sensor" error you're getting on the display of your Lippert leveling system like the Ground Control #LC358590 indicates an issue with the rear leveling sensor. This particular sensor should be located a few feet behind the…

For a weight distribution shank that has 2 more inches of drop than the part #RP54970 you'd want the part #RP63971.

The best way to pick out a weight distribution system is to base it off of the loaded tongue weight of the setup when it is loaded and ready to tow. This figure also includes the weight of any cargo behind the rear axle of the tow vehicle. I attached…

Yes, the cam of the Reese Dual Cam III part #RP65FR has been upgraded from models that were made 20 years ago. The brackets have also been upgraded and made to be a lot easier to install as well.

Weight Distribution is a good idea whenever the loaded weight of the trailer weighs more that 50 percent of the tow vehicles weight. In addition to eliminating the squat experienced when a trailer is connected, a weight distribution system has other…

The overall length of the Replacement Trunnion Spring Bar part #RP22225 from the end of the trunnion to the end of the bar is 33". I have attached a photo with this measurement for you as well. This spring bar is a direct replacement for Reese…