RV Bumper Hitch Recommendation that Can Mount Below Bumper

Question

Question:

Can this receiver be mounted up-side down, nuts and bolts on bottom of bumper?

asked by: Bill

0

Expert Reply:

I have a solution for you, but the RV Bumper 2" Trailer Hitch Receiver # S64025 that you referenced can only be used with the hitch opening on top of the bumper.

Instead you would want the Ultra-Fab 2" Motor Home Trailer Hitch # UF35-946401. This hitch can be used with the opening on the bottom of the bumper. Be sure not to exceed the weight capacity of your bumper, check the owners manual of your vehicle for more info on that.

expert reply by: Jameson C

0

Answer 1

Curt has stated that there is no reason you couldn't install trailer hitch #E-100 with the hitch opening above the bumper. I spoke with my contact at Curt and he confirmed that this would be just fine. This should provide the additional height…

view full answer...

Answer 2

I took a look online, the Curt Trailer Hitch item #C13105 you have on your Sienna is rated to be used with a weight distribution system. The best one for your 2,100 lbs pop up camper is going to be the Equal-i-zer Weight Distribution System item…

view full answer...

Answer 3

30lb propane tanks will measure roughly 24" in tall so the Stromberg Carlson Trailer Tray Cargo Carrier for A-Frame Trailers #CC-255 would have enough clearance since it sits 29" above the trailer frame. In the attached video below you can…

view full answer...

Answer 4

If your Micro Minnie has a 4 inch x 4 inch channel bumper, I'd recommend the Curt #E-100. If you'd prefer a frame mounted hitch, I'd recommend the Curt #13703, which is compatible with box, C-channel or I-beam frames that are between 22…

view full answer...

Answer 5

The Husky Center Line Weight Distribution with Sway Control 32217 is for 600 lb to 800 lb total tongue weight capacities (the tongue weight of your fully loaded and ready to go trailer plus the weight of any cargo behind the rear axle of your tow…

view full answer...

Answer 6

I went to the warehouse to measure and found that the bolt holes of the Buyers Products RV Bumper Receiver Hitch #337RVA24 measured 3/8". This hitch fits a standard 4" or 4-1/2" square tube RV bumper and should only be used for…

view full answer...

Answer 7

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 8

The Adjustable Width Trailer Hitch Receiver for RVs, 22" to 66" Wide #C13704 has brackets that are 10 inches long with mounting holes 8-1/2 inches center on center. The height is right at 5-1/2 inches tall. I've attached a video to…

view full answer...

Answer 9

The Reese #RE44FR would indeed offer weight distribution and sway control. The kit includes a 2-5/16 inch trailer ball and the adjustable weight distribution shank. The system is rated for trailers with a 600-1150 lb fully loaded tongue weight. You…

view full answer...

RV Bumper Hitch Recommendation that Can Mount Below Bumper

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching