Chevrolet Silverado New Body Truck Tailgate Lock

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

I checked with Pop & Lock for you and there is a system that they have confirmed will work with 2011 and newer Leer 100XL, Leer 100XQ, and Leer 700: - Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers…

The Tonneau Cover Adapter Kit #Y01155 is only a fit for the integrated tracks on Retrax XR Series, Embark LS and Pace-Edwards UltraGroove (except for 2004+ F-150) tonneau covers. While your Roll n Lock tonneau cover does have t-slots for some…

The Leer 100XR isn't specifically listed by Pop and Lock but more than likely the #PAL9772 will fit. It requires a frameless, bonded glass door with a 1-1/8" center hole for a rotary latch. This particular kit would upgrade your…

The Bauer Products T-Handle Lock for Truck Caps #BA57VR comes with a J-327 key. So by ordering 3 of these they are all keyed alike. This particular handle is for locks rotating counterclockwise. We also have the Clockwise T-Handle #BA84VR if your…

The Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers #PAL9772 will work on the A.R.E. MX series truck cap you referenced on your 2017 Ford F-250 Crew Cab Short Bed. This will give you a clean look along with the…

The tonneau cover and rack system you are referring to from that answer - a Retrax XR cover and Yakima ladder rack - is absolutely compatible with a 2020 Toyota Tundra with a 5-1/2 foot bed, it will just require some different part numbers, and the…

Most A-Frame Trailer Couplers have a standard of 50 degrees. I produced a short video for you showing the angle of the etrailer A-Frame Coupler, part #CA5400. I have also linked an FAQ on trailer couplers.

The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately 9" long. I have include…

Unfortunately, Atwood no longer has the repair kits available. They were bought out and the company that now owns them stopped producing the repair parts you need. I recommend the A-Frame Trailer Coupler - Yoke Latch #CA-5210-B for your replacement…

The standard a-frame coupler degree is 50 degrees but we do have a 32 degree coupler with the part #DM15633-81 but the rear width of it is 9-7/16 inches.

It would appear that that your 1978 Airstream had the standard 50 degree a-frame style coupler. You can verify this to ensure that the etrailer A-Frame Trailer Coupler #CA-5280-RB will fit correctly on your Airstream. I personally prefer the auto…