Custom Fit 2009 Chrysler Town and Country Accessories

I have attached a chart for you to take a look at that includes the lug nut torque specifications. If your wheel uses 1/2 inch lug nuts or wheel bolts like the 12 Inch Steel Spoke Trailer Wheel #AM20124 referenced in your question, you will torque…

The correct torque value would depend on the diameter of the wheel stud (not the wrench size needed to remove the lug nut or bolt). • 7/16 inch stud- 55-65 ft-lbs • 1/2 inch stud 75-78 ft-lbs • 9/16 inch stud 95-115 ft-lbs These torque values hold…

Wheel studs can break from too much torque on them or from having them too loose which creates movement which can eventually cause them to break. My brother kept breaking wheel studs on a car he had because he was using the wrong lug nuts. In your…

To make sure we choose the correct wheel and hub for your trailer, we are going to need a little more information about the spindle on your trailer. I assume the 1.250 shaft that you mention is the spindle on your trailer. Most trailer spindles are…

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

A hair dryer is exactly what works great when using the Deka Heat Shrink Butt Connector, part #DW05743-10. Using these butt connectors will help keep any moisture and dirt out of the connection for you.

The problem you are having is a classic ground issue. If the ground wire to the trailer frame or the tail light grounds are not connected securely to clean, rust and paint free surfaces then when the headlights are turned the extra amperage draw for…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

You are correct that you can use a 2-to-3 converter, the Curt #C56196, to separate the combined circuits on your 2009 Chrysler Town and Country so your brake lights and turn signals will operate independently of one another. In regards to Diodes…

Replacement bearings, races, seals, etc. can best be identified using the original part numbers, but in cases where those part numbers are not available it is possible to measure the trailer spindles with a precision caliper (to the nearest…

Yes, the Curt trailer wiring connector part #C56333 that you referenced does require running a wire up to the vehicle battery. This allows your trailer's lights to be powered directly from the vehicle battery and not through the vehicle lighting…