Trailer Wiring Harness Installation - 2006 Dodge Dakota 55323 Video

For a 2006 Dodge Dakota that does not have the factory tow package you will need to hardwire in a trailer brake controller. The first thing you will need is a 4-Way trailer wiring harness, #118323. If the truck already has a 4-Way you will not need…

I spoke with K Source, the manufacturer, and they stated that certain models like the #KS60113-114C have a sensor that communicates with the control button to know when the mirror is in normal or the tow position so that the buttons function…

Since your factory roof tracks are removed, you will need a complete roof rack kit that includes the roof tracks. I think your best option is to go with Rhino-Rack Aero Bar Roof Rack #Y02-480B.. This kit includes 63" long tracks that will be…

The 12 inch tires that we carry are rated for 65 miles per hour. Any faster than that for extended periods and the excessive heat build up will cause tire failure. To get a tire with a higher speed rating you would have to go up in size. That also…

Special trailer tires are usually rated to operate at a maximum speed of 65 mph. If you exceed 65 mph, heat could build up in the tire and cause it to break down and fail. If a tire is rated to run at a higher speed. The two part numbers #AM3H200 and…

To determine the maximum trailer weight you can tow with your 2006 Dodge Dakota you will need take your Gross Combined Weight Rating (GCWR) on your truck. This is the maximum allowable tow rating of the vehicle weight and the trailer weight combined.…

The port under your hood that the Hopkins Plug-in Simple Brake Wiring Adapter #HM47755 you referenced plugs into will be under the dash just to the right of the emergency brake. Check out the picture I attached that shows exactly where it is. You…

Electric brakes do not use brake fluid. They work by a brake controller sending back voltage to an electro-magnet. When energized the magnet stick to the armature surface of the brake drum. The spinning of the drum pulls out the brake shoes and the…

I see that you purchased Curt 4-pole wiring harness #55323 back in 2012. Since this is a passive harness that plugs in at your Dakota's tail lights the most-likely cause for your lighting issue is damaged or corroded connector contacts within the…

Yes, the trailer wiring kit part #55323 that you referenced is a fit for your 2011 Dodge Dakota and will work well for what you are looking to do. It installs by plugging in line with the tail light wiring of your truck which allows it to bypass the…