Blazer Light Buster Backup and Utility Light Review Video

Yes, the Redarc Tow-Pro Elite Trailer Brake Controller part #RED44FR draws milliamps of power while in sleep mode but it would take much longer, even several months of the vehicle sitting to completely drain the battery usually. The Tow-Pro Elite…

One of the great features of the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR is the versatility when it comes to mounting the control knob. Most brake controllers need to be mounted a specific way with the controls on the face of it.…

Yes we do carry the Redarc Tow-Pro Elite Trailer Brake Controller #RED44FR. Use Plug-and-Play Wiring Harness #RED39FR to install the brake controller on your 2017 Nissan Frontier. This is a simple plug-in installation process, just find the…

The user controlled mode on the Redarc Tow-Pro Elite Trailer Brake Controller part #RED44FR will act similar to a timed-delay brake controller. Therefore, the amount of power applied to the trailer brakes when in the user controlled mode will ramp…

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

You'll need a small slot screwdriver to slide into the slot you see the arrow in the picture I attached pointing out to gently pry off the lens.

The Momentary Switch #37212705 is not waterproof however the Single Momentary Reversing Switch #37213865 is going to be your best bet as it's water-resistant. This switch is similar to #37212705, is made in the USA, measures 1.12"…

We have the Light Buster Backup and Utility Light for 7-Way RV Style Connectors #C8020 which plugs into the 7-way trailer wiring connector you have at the rear of your vehicle and will give you a brighter lighting when backing up at night.

Yes, you can power and ground the LED license plate light #LPL91CB using the 7-Way trailer connector. The power wire would run to the running light circuit and ground to the ground circuit. If you wanted to wire those up to a trailer-side 7-Way you…

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more…

Factory wiring could be any color since there is no one standard that all manufacturers follow. You will need to test the wires by function using a circuit tester such as #PTW2992 if you do not already have one. I have included a picture that shows…

If your vehicle is set up to only be able to tow a trailer with incandescent lights. Then you would be able to replace all of the trailers lights with LEDs and it would, in theory, work just fine. Since we have never heard of a vehicle being only…