Trailer Wiring Harness Installation - 2012 Honda CR-V Video

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

The Curt MV Weight Distribution system part #C17062 that you referenced weighs 101 lbs.

For your 2014 Honda CR-V I highly recommend the Curt Class III Trailer Hitch Receiver #C13119 for a couple of reasons. All of the Class III custom hitches (I recommend going with a Class III not only for the extra capacity but for the larger 2"…

We do have a photo of the Curt Hitch, part #C13119, on a 2012 Honda CR-V and I have posted it on the page. The most visible part will be the receiver opening and the front of the round crossbar. I have also linked the installation detail for this…

The drivers side bolts will not bolt through the appearance panel. There will be an 8-1/2 inch by 4-1/4 inch cutout in the appearance panel for the drivers side bolts. This cutout will give you enough room to bolt the hitch on and leave the…

I'm not sure which year your Honda CR-V is but I saw you looked at the trailer hitch receiver that fits the CR-V from 2012 to 2016 so I checked a manual for the 2016 model. It states, on page 353, that the maximum towing capacity is 1,500 pounds…

BMWs and Hondas are very different vehicles so you would need a different hitch for the 2013 Honda CR-V to carry your Thule bike rack. You would want the Draw Tite Hitch part #75742 as this is a 2 inch hitch confirmed to fit your vehicle that would…

Both the front-wheel-drive and all-wheel-drive versions of the 2012 Honda CR-V with automatic transmission can be flat-towed behind a motor home. Honda cautions that before flat towing your CR-V transmission fluid level and condition be checked. If…

You are correct. In the instructions, linked for reference, for trailer hitch #75742, the rectangle with the slashes through it is the area that needs to be trimmed. The measurements there are so you can trim in the right place. I have included a…

I believe that the photo you sent in is of the OBD-II port on your 2014 Toyota Tundra. This is useful if your vehicle is throwing codes but it is not used for the brake controller. As long as your Tundra has the factory 7-Way at the rear of the truck…

We had the chance to install the Rhino Rack roof rack you have #RRVA118B-2, #RRRLKVA, and #DK438 on a very similar 2016 Honda Fit and we found that the feet fit to the inside of the channel you mentioned. Check out the picture I attached to see this.…

Yes, the Kuat Dirtbag Bike Rack's like part #DRT15X110 and part #DRT9P will work with the Saris Traps Fork-Block Bike Carrier Base part #SATRK33. I have attached a few photos to show the fitment for you.