Trailer Hitch Installation - 2015 Toyota Corolla - Curt Video

The problem you are experiencing sounds like a ground issue and/or short circuit. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or…

The ideal height will actually have to do with how tall the coupler of the trailer is from the ground. The Draw-Tite #76020 will sit at 13 1/2 inches from the ground to the top of the hitch when installed on a 2016 Mazda CX-9. From what I could find…

In my opinion you are going in the right direction with a frame mounted receiver. The only advantage to a weld on application is that, if welded properly, the attachment point, weld, will be stronger than the hitch or trailer frame steel and one of…

For your 2015 Toyota Corolla the Sportrack Roof Rack part #SR1010 is a confirmed fit, but I have a better solution for you since this is a semi-custom rack that won't give you the best fit possible. For a lower priced roof rack that will fit and…

The best way to haul your dirt bike will be with a trailer as the frame of your 2010 Toyota Corolla is not strong enough to support that much weight on the hitch. The Curt Trailer Hitch Receiver #C11265 will allow you to haul a trailer with your…

In order to tow a 5x8 trailer from U-Haul with your 2017 Toyota Corolla, you will need a trailer hitch, wiring harness, and ball mount. Starting with the trailer hitch, I recommend the Draw-Tite Sportframe Trailer Hitch Receiver #24913. This Class I…

The 10 amp fuse that is included with the Curt T-Connector Vehicle Wiring Harness part #C56217 will need to be the one that you insert into the #29 slot. The owner's manual does indeed call for a 30 amp fuse here but that is with the factory…

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

The 5-way flat trailer connector in-line circuit tester #20115 you referenced won't be needed. You would need to have a 12V power source and your jumper wire which will let you know if you have working trailer lights. The most common gauge…