Trailer Hitch Installation - 2004 Jeep Wrangler - Curt Video

The Thule Apex #TH9027XT has similar dimensions to the Yakima Full Swing #Y02465 and will come in contact with your spare tire if you try to swing the back trunk door open. I attached a picture where we tried this bike rack with a Jeep with a spare…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To see the torque specs for the Draw Tite Hitch part #75193 check out the link to the installation instructions I attached to the right. Since the specs are subject to change we do not post them on our site. We link the installation instructions…

Assuming the carrier has the clearance needed to fit past the spare mounted at the back of your 2006 Jeep Wrangler the best option would be mount it on the Wrangler with a hitch like the #75193 when we installed this rack on a 2006 Jeep Wrangler we…

Having your towbar within 3 inches high or low of level is perfectly acceptable, according to Blue Ox and Roadmaster. If the #RM-077-4 would allow the towbar to be within that amount plus or minus of level, the dual hitch adapter would work just…

There's nothing stopping you from using a Holding Tank Heater Pad such as #277-000164 on black or gray water tanks. However with the black water tank adding a heat source could create excess gases which could be a potential problem.

You can use Yakima Replacement Hitch Bolt and Clip #Y8890200 for your Holdup bike rack. This threaded pin is shown in the linked measured diagram and video. Overall length is 4-9/16-inches. This will give you the bolt length you need for installation…

Even though the plug was found on the driver's side it does sound like your mechanic found the correct plug for the Hopkins #42615 on your 2003 Jeep TJ. If the lights on your Jeep are working normally then that leads me to believe that the wiring…