Can Manual Pull-Out Step be Installed on a Horse Trailer

Question

Question:

can this step be added to my trailer

asked by: Patricia C

0

Expert Reply:

Technically you can add any Manual Pull-Out Step like # LC432678 to your trailer. You may need to also add outriggers # LC301704 to the frame in order to get the step in the right position and if you can't attach it reasonably to the desired location.

expert reply by: Michael H

0

Answer 1

The correct Timbren suspension kit for your 2014 Ram 3500 4x4 is the kit part #T94VR which we know is a confirmed fit for your truck and will work well.

view full answer...

Answer 2

Great question. Suspension Enhancement Sytems (SES) are intended to assist suspension in good working condition, but will not correct any bowing in your axle or increase the towing capacity of your vehicle. Assuming your vehicle suspension is in…

view full answer...

Answer 3

The Timbren Rear Suspension Enhancement System, part #TDR3500CA is a confirmed fit for your 2015 Ram 3500. The system does come with a 1 inch spacer just in case you need additional length. I have attached a drawing that shows the clearance that…

view full answer...

Answer 4

The best option would be a fold out step setup for your horse trailer where you need a height of 26 inches. The Lippert manual pull out step part #LC432690 would be a fantastic option. When it's out you have 25 inches from the mounting…

view full answer...

Answer 5

The Ark Drop Down Corner RV Stabilizer Jacks #ARK94FR are able to lock into place at 30 and 60 degrees as stabilizers. They also have the 90 degree position where it is rated for 1,929 lbs and then the stored position.

view full answer...

Answer 6

The slight gap you see is normal. The drum is not supposed to make contact with the brake mounting plate. There are some instances when mixing brands of brakes, hubs, and axles, that won't line up properly but in this case it is normal. I…

view full answer...

Answer 7

Both of the ARK stabilizer jacks #ARK94FR and #ARK87FR can rotate 90 degrees forward and back so in a way it is 180 degrees like you asked about. The difference is the #ARK94FR has a square tube and #ARK87FR has a round tube. These are both going…

view full answer...

Answer 8

Your 2016 Wildwood camper was made by Forest River which typically uses Lippert frames, so the Lippert pull out steps part #LC432682 should work well for you. However, you can measure your current steps and compare them to the dimensional pictures I…

view full answer...

Answer 9

Those are Warner trailer brakes. This style is not made anymore and replacement parts are hard to find. We have some parts for the larger Warner assemblies but NOT the 12 x 2 inch ones. Most people end up replacing them. You will have to have…

view full answer...

Answer 10

The Lippert part number 173552 you referenced comes back to the Lippert Manual Pull-Out Step for RVs #LC432682. Because there is a bit of cross over with these item numbers it's best to take a quick measurement of what you currently have to…

view full answer...

Answer 11

I spoke with Lippert about the Lippert Components Kwikee Step Frame 28 Series Step part #LC3747457 and unfortunately, they do not provide any mounting information as this is done through the trailer manufacturer. They did however state that you…

view full answer...

Can Manual Pull-Out Step be Installed on a Horse Trailer

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching