Trailer Brake Controller Installation - 2006 Ford Expedition Video

I spoke to my contact at Lippert Components (LCI) and they informed me that the Lippert Components Kwikee Revolution Step Control Module part #LC363980 is the correct replacement model for your Lippert Components Kwikee Revolution Steps pn…

Yes, all brake controllers including the P3 #90195 must have a manual override lever. The P3 manual override lever is located on the bottom. I included a picture pointing it out for you.

According to Dexter, the #58-8 Predator DX2 needs to be mounted in the direction of travel, level on a side to side plane. If mounted on vertical plane as you mention, the brake controller would not function. If the vehicle design somehow limits the…

On your 2006 Ford Expedition, there should already be a factory installed trailer connector. It will either be a 4-Way flat or a 7-Way blade. If your vehicle has a 4-Way flat, you will need to add Adapter 4 Pole to 7 Pole and 4 Pole, #37185. On this…

You are correct. That blue wire carries the output from the brake controller. To convert your 4-pole to a 7-way, use an adapter like part #37185. The connector on the adapter would connect to your existing 4-pole. The remaining wires would connect as…

Sounds like you have both a factory 4-way and 7-way at the rear of your 2007 Ford Expedition. Because of that all you would need to install the Prodigy P3 Brake Controller part #90195 that you referenced is the correct wiring harness, part #3035-P.…

The 1998 Ford Ranger is not pre-wired for a 7-way. You can convert your 4-pole to a 7-way by using our kit #ETBC7. This kit includes a 7-way socket, wiring, connectors, circuit breakers - in fact all the parts you need to have a 7-way with 12V power…

I looked up the trailer connector wiring diagram for a 2007 Ford F-250 which should be the same as a Ford F-350 and found the 7-way trailer connector to contain the following wires: Orange = 12 Volt Power White = Ground Black/Green = Reverse Blue =…

The length of wire desired depends on your vehicle connection and your personal preference. You want enough slack for turning, but not so much for dragging as you mentioned. A little extra slack isn't a problem and not enough could lead to stress…

We can help you with new lighting and wiring for your 16-foot trailer. A trailer's type, size and weight determine the type and number of lights it must legally have to be compliant with DOT regulations. We have a helpful article that covers…

I recommend using Adco SFS AquaShed Cover #290-46002. It is designed for bumper pull trailers with up to a 12' box length. It does include zippered panels on the side and rear so that you can still access your trailer while the cover is in place.…

We have run into this quite a few times in the past, and the best option will be replacing the Lance 7-pin connector with a standard 7-way blade connector like the #PK12706. This will give you a standard 7-way connector to plug into the factory 7-way…