Roadmaster Variable Voltage LED Tail Lights Wiring Kit Installation - 2023 Jeep Wrangler 4xe Video

The Roadmaster Tow Defender Protective Screening #RM-4700 has some movement where it attaches on the RV side that keeps it as straight as possible to reduce the chance that the fabric would hang too low. However it is possible for it to touch the…

A base plate kit is the hardware that gets bolted to the front of a vehicle which is what provides the attachment point for a tow bar when flat towing. I attached a link to this page that is a help article that covers what base plate kits are as well…

Both the Roadmaster and Blue Ox tow bars are great options. But if it was my decision to make I would go with the Blue Ox Avail part #BX7420 as we have found that the Blue Ox tow bars are a little easier to connect and disconnect from. Also this tow…

For a 2023 Jeep Wrangler 4XE you'll need the following components: Baseplate: Roadmaster Direct-Connect Base Plate Kit #RM-521453-5. These custom-fit baseplates are designed to work with factory bumpers, if you have an aftermarket bumper please…

Yes, The Roadmaster Brake-Lite Relay Kit for Towed Vehicles #RM-88400 will work with your wiring system to ensure that your towed vehicle's turn signal lights flash in tandem with your RV's lights. Using this relay will not interfere with…

According to Roadmaster, the 1.8V reading is in the acceptable range on your #RO54FR. The smart diode has built in resistors which take the voltage down low like that. It gets especially low for the LED version since it takes very little to power an…

In regards to the Roadmaster Battery Charge Line Kit for Towed Vehicles part #RM-156-25, the included circuit breaker does not need to be mounted to a metal surface. The installation instructions are as follows, "Find a suitable mounting…

To determine if your motorhome has the Tiffin air brake setup or Freightliner BrakeSync you'll need to look at the rear and see if there's an quick disconnect fitting for your air line. The standard Tiffin air coupler fitting would look like…

For a single diode to prevent current backfeed the part #RM-790 would be a great option.

I did some research and what I believe is happening is that your motorhome has combined lighting and your Jeep has separate and the brake lights are overriding the turn signal lights. I contacted Roadmaster and they recommend to use the Roadmaster…

Appreciate the purchase of the Roadmaster InvisiBrake Supplemental Braking System #RM-8700. And as far as the trickle charge, the InvisiBrake does provide up to a 2 amp charge on your battery if the running lights are on, so if the running lights are…

Yes! You can provide a maintenance charge to the toad's battery through terminal A (the 12 volt circuit) using Hopkins Endurance Flex-Coil Trailer Connector Adapter #HM47053. You would just need to attach one end of a wire, #12-1-1 (sold by the…