Roadmaster Direct-Connect Base Plate Kit Installation - 2019 Jeep Wrangler Video

Yes, The Roadmaster Brake-Lite Relay Kit for Towed Vehicles #RM-88400 will work with your wiring system to ensure that your towed vehicle's turn signal lights flash in tandem with your RV's lights. Using this relay will not interfere…

According to Roadmaster, the 1.8V reading is in the acceptable range on your #RO54FR. The smart diode has built in resistors which take the voltage down low like that. It gets especially low for the LED version since it takes very little to power…

This is a good question. So it really comes down to preference between the Roadmaster base plate kits that have the crossbar and the ones that do not. The kits like you have #RM-521453-5 without the crossbar are actually reinforced more at the welds…

I have exactly what you need to operate the lights on your 2019 Jeep Wrangler using the signals from your 2005 Fleetwood Bounder Motorhome. For this, I recommend the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit part #RM-15267 which comes…

To flat tow the 2020 Jeep Wrangler I recommend the Roadmaster Diode 7-Wire to 6-Wire Wiring Kit part #RM-15267 because of it's nice clean install. The Roadmaster kit will give you a 6-way round at the front of the Jeep with a coiled cord to…

The LED lights on your 2018 Jeep Wrangler JL use the same wiring harnesses available for incanescent lights. I've linked our selection for you. I like to recommend the diode kit, part #RM-15267, because it installs a 6-way at the front of the…

In order to flat tow your 2019 Jeep Wrangler I highly recommend the Roadmaster Diode 7-Wire to 6-Wire Flexo-Coil Wiring Kit #RM-15267 because it is designed to prevent electrical feedback and will ensure your Wrangler's electrical system remains…

Both the Roadmaster Direct-Connect Base Plates #RM-521453-5 and the Crossbar-Style Base Plates #RM-521453-4 will fit your 2020 Jeep Wrangler Unlimited perfectly (as long as you have the factory plastic or steel bumper). The difference between the two…

I went ahead and contacted my tech at Roadmaster, and he confirmed that while he doesn't have the exact measurement below the bumper where the Base Plate #RM-521424-5 installs on a 2004 Jeep TJ, he did confirm that the pins on the baseplate sit…

The diode part #RM-790 that you referenced does exactly what you are looking to do. It takes two power sources and can combine them onto one wire and prevents backfeeding from either circuit. So for what you need this would work well.

The difference between the EZ 4 #RM-521453-4 and the EZ5 #RM-521453-5 base plate kits is that the EZ 5 is a direct connect with no crossbar and the EZ 4 doesn't use a crossbar. Essentially, you'd want to match the base plates to the tow bar…

I looked though the online version of the owner's manual for your 2018 Jeep JK Wrangler and there isn't a clear indication as to whether or not the key should be left in the ignition while it's being flat towed. There is a detailed…