etrailer Class III Trailer Hitch Installation - 2022 Jeep Renegade Video

The best hitch for a 2023 Jeep Renegade is the etrailer Hitch item #e37AR. This hitch is custom fit and bolts to your Jeep with included hardware. This is our house brand hitch but it is manufactured by Curt and is identical to their item #C13269…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

When we had the chance to install the Draw Tite hitch part #76021 on a 2017 Jeep Renegade like yours we found that the ground clearance ended up being right at 9-1/2 inches.

On the Curt Ball Mount #C45090 the distance from the center of the hitch pin hole to the near edge of the reinforcing gusset is 3-inches. From the hole center to the end of the shank the measure is 2-1/2-inches. I prepared a photo diagram for you to…

It sounds like you are asking about the distance from the center of the hitch pin hole to the back of the shank of the ball mount that slides into the hitch. That distance is 2-1/2 inches. I attached a picture that shows this dimension as well.

You will need to remove the M14 frame bolts of your 2015 Jeep Renegade Trailhawk to install the part #76021 that you referenced. The vehicles that have the towhooks will use the factory bolts for installation. Vehicles without tow hooks use the…

With the Curt Trailer Hitch Receiver #C12142 installed on your 2017 Jeep Renegade Trailhawk you will have roughly 10-1/4" clearance. Since the ground clearance will be very similar to that of the Draw-Tite Trailer Hitch #76021 you had looked at…

We actually had the opportunity to install the Draw-Tite Max-Frame Trailer Hitch Receiver #76021 on a 2018 Jeep Renegade Latitude and found from the ground to the top of the receiver tube is 10-1/4". Since this is a 2" receiver we can…

For lighter duty vehicles like your 2018 Jeep Renegade the manufacturers won't recommend the vehicle tow anything due to a number of reasons. Sometimes the engine may not have enough power but usually it's related to where the hitch would…

The install video you referenced (that I attached a link to) had an older version of the Draw Tite hitch part #76021 installed on it. The install of the current version of this hitch would be the exact same. I attached a picture that I think will be…

Hitch rattle can be a common issue and there are some easy ways to relieve the noise. The easiest solution is to bend the exhaust hanger up so that the muffler sets further above the hitch. I have attached a photo showing the exhaust hanger for you.…

When you install an aftermarket part on your vehicle like the Draw Tite hitch #76021 in this case on your 2018 Jeep Renegade, you are protected by the Magnuson–Moss Warranty Act. This act states, in part, that unless the installation and the part…