Draw-Tite Max-Frame Trailer Hitch Installation - 2018 Acura RDX Video

The etrailer Trailer Hitch Receiver #e98840 is a great option for your 2018 Acura MDX! You can find the torque specs in the linked instructions. We always refer to the instructions for the specs as these can sometimes change depending on what…

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

If you have a 2017 Toyota Tacoma with the tow package/factory 7-way yes it is pre-wired for a brake controller. For a brake controller I recommend the Prodigy P3 Brake Controller part #90195. This is our best selling brake controller because of how…

We spoke with our contact over at Tekonsha and they told us that brake controller wiring harness #3031-P is a fit for the 2017 Toyota Tacoma. If you do not already have a brake controller I recommend the P2 #90885 because it is easy to set up and use…

I would be happy to help! I had our warehouse measure the Draw-Tite Trailer Hitch Receiver #76116 you were looking at and it measures 4-7/8" from the center of the hitch pin hole to the back of the receiver as shown in the included diagram. For…

Usually when you replace parts that get lubricated, you clean all of the existing grease first before adding any new grease, just in case there is a compatibility issue. Since you are using Dexter axles and replacing components with Dexter parts, the…

To adjust the hitch latch on your trailer's coupler, you will want to adjust the nut at the bottom of the latch. This nut will be tightened or loosened depending on what you need for your coupler. I have attached a diagram showing you the…

You are correct. When you set up the brake controller for the first time, you set the power to 6 with no boost, drive the vehicle and trailer on a flat surface at 25 mph, then fully apply the manual override. Adjust the power as needed to reach a…

For your 2018 Acura MDX the aftermarket trailer hitch that will be most similar to the OEM/factory unit is the etrailer.com Class III Hitch #e98840. The primary difference between the OEM hitch for the Acura MDX and an aftermarket model is their…

We have confirmed that the Draw Tite part #36114 does for sure fit your 2021 Acura RDX. You would not need to measure the width of your vehicle frame/chassis to determine if this will fit as we know it does. It is the exact same as the 2020 models.

As long as the controller is installed parallel to the direction of travel, and is level on a side-to-side plane, you can certainly mount the Tekonsha Prodigy P3 #90195 at a 45 degree angle to match the slope of your vehicle's dashboard. If you…

The Tekonsha Prodigy P3 Trailer Brake Controller part #90195 will go into a sleep mode after 15 minutes of inactivity. Therefore, with the vehicle shut off and the key out of the ignition it will still stay on till the 15 minute window is reached.…