Curt Spectrum Trailer Brake Controller Installation - 2016 Acura MDX Video

For a 2007 Lexus GX470 with the factory 7-way installing the Curt #C51170 Spectrum brake controller would be a plug and play installation. Other than the #C51362 brake controller wiring harness, no other parts would be needed. The connector for the…

The red wire from your Dexter DX2 brake controller #58-8 needs to be wired to the cold side of the stop light switch, which on your 2013 Chevy Silverado corresponds to a light blue wire with a white stripe. This wire should ONLY be hot when the…

To install the Prodigy P3 Brake Controller #90195 all you will need is the wiring harness part #3040-P that you referenced. This adapter plugs into the 5-pin connector on your vehicle's built-in brake control wiring harness. The harness is…

I went out to our warehouse to measure the bracket for the Curt Spectrum Trailer Brake Controller #C51170 that you referenced and found that it has an outside diameter of just under 2 inches (1-15/16 inches to be exact). I have attached the image…

To connect your vehicle that has a 4-Way flat connector to your trailer that has a 7-Way connector, you will need to install a 7-Way on the rear of your vehicle. If you just want or need the tail light functions to operate on your trailer you will…

The etrailer Tongue Weight Scale for Campers and Utility Trailers - 2,000-lb Capacity, #e99044 is compatible with your Scamp as it fits 1-7/8", 2", or 2-5/16" ball couplers. If your Scamp was ordered with a jack that has a 2"…

When using the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation #ETBC7 to install the Curt Echo Mobile part #C51180 you can just tape up the blue wire of the adapter as it would not be used.

Unfortunately, you will have to run a second power line for the 7-Way RV Upgrade Kit for Trailer Brake Controller Installation - 12 Gauge Wires, part #ETBC7L, if you need the 12V accessory power for your trailer. The circuitry of each connector is…

In order to install a seven way trailer connector and brake controller on a 2017 Toyota RAV4 (All Models) you'll need to start with a four way, the T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector part #118578 which is…

You could use the #ETBC7 to just install the Curt Echo Mobile part #C51180 if you wanted to but you'd have more parts than you'd need so it might be easier just to use the #37185 as the adapter and then run 10 gauge wire like part #10-1-1…

The white wire from the Autowbrake Electric Brake Controller #3430001 is for ground so you will just want to make sure it's securely attached to a clean bare metal surface. A weak ground can definitely prevent proper operation on the brake…

First I suggest making sure you are testing the brake circuit pin on your Sierra's 7-way trailer socket. If you refer to the linked photo of a trailer connector you will note the brake controller's output is carried on the pin at the 5:00…